Skip to contentSkip to conversation

Problem: ICH6 SATA + ACPI resume

DISCUSSION Jeff Garzik 1 participant 1 message Sep 14, 2005 1 message not in the archive libata

lore
Share & tools
lore
#1 lore raw
In reply to a message not in the archive
Quoted 5 lines · Alexandre Fiori

Hello,

I'm facing a weird problem with SATA and ACPI. I was using linux 2.6.12.5 <http://2.6.12.5> and now 2.6.13.1 <http://2.6.13.1>, and the problem persists.
If I use the ATA "Generic PCI IDE" or even "Intel PIIXn" the harddisk is very slow but I can suspend and resume, everything works fine - although it is very slow.
Now I disabled ATA support and changed to the SCSI "Serial ATA/Intel PIIX/ICH SATA". The disk performance increased from 2 to 35MB/sec and I still can do the ACPI suspend (now via echo -n mem > /sys/power/state), but when I resume I get a lot of errors from the driver on the console.

Suspend/resume is not supported yet, in libata.

Jeff