Skip to contentSkip to conversation

Where is all the commands?

U-Boot-Users 25an 2 participants 2 messages Feb 28, 2007

lore
Share & tools
lore

25an

author
#0 lore raw

Hi!

I have just managed to compile u-boot and managed to run it on the board (AT91SAM9261ek) but one of the reasons why I compiled it and did not just use the
u-boot.bin that came with board was that it did not have all the commands that
the DENX U-Boot manual mentioned.
Fore example I am missing the iminfo,bdinfo,diskboot and dhcp commands. Any thoughts about this.

Thanks

Signature · 2 lines
View this message in context: http://www.nabble.com/Where-is-all-the-commands--tf3307710.html#a9200692
Sent from the Uboot - Users mailing list archive at Nabble.com.
#1 lore raw

Hi

Quoted 4 lines
Quoted 1 line
Quoted 1 line

25an<[email protected]> 28.02.07 10:35:28 >>>

Hi!

Quoted 8 lines

I have just managed to compile u-boot and managed to run it on the board (AT91SAM9261ek) but one of the reasons why I compiled it and did not just use the
u-boot.bin that came with board was that it did not have all the commands that
the DENX U-Boot manual mentioned.
Fore example I am missing the iminfo,bdinfo,diskboot and dhcp commands. Any thoughts about this.

Take a look at the README, (look for Monitor Functions). Then change the define CONFIG_COMMANDS in your include/configs/<board.h>.

Best regards