Skip to contentSkip to conversation

V2 of OMAP3 USB device Support

U-Boot Remy Bohmer 2 participants 2 messages Sep 29, 2009 1 message not in the archive

lore
Share & tools
lore
#1 lore raw
In reply to a message not in the archive

Hi,

2009/9/28 <[email protected]>:

What is the difference between sender 'y' and 'Tom Rix'? I guess I can safely ignore the 'y' sender...?

Remy

Quoted 42 lines

The technical change is better handling of address setting on the usb handshaking setup phase.

Other changes from Jean's comments

2/8 USB add macros for debugging usb device setup.

static inline function replacing debug macros

3/8 TWL4030 Add usb PHY support

add empty lines between variables and statements
other empty lines added for readablity

4/8 OMAP3 Add usb device support

80+ char lines reduced
Used MUSB_FLAGS_PRINT macro suggestion
lowercased function names
multi-lined ep0_state_enum
Used suggestion on udelay to 1000 * 1000
add empty lines between variables and statements
inverted check of ep0_urb->device_request.wLength
other empty lines added for readablity

5/8 OMAP3 zoom1 Add usbtty configuration

This was ack-ed by Jean

6/8 OMAP3 beagle Add usbtty configuration

This was ack-ed by Jean

8/8 OMAP3 zoom2 Use usbtty if the debug board

cleanup using usbtty_* functions or their stubs without #define's
_______________________________________________
U-Boot mailing list
U-Boot at lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

#2 lore raw
Quoted 8 lines · Remy Bohmer

Hi,

2009/9/28 <[email protected]>:

What is the difference between sender 'y' and 'Tom Rix'? I guess I can safely ignore the 'y' sender...?

Remy

Yes ignore the 'y' sender
I bungled the git send-email.
I tapped 'y' twice on the send-email command.

I will also look into changing my mailing id to just 'y'. :P

Tom