Skip to contentSkip to conversation

AMCC 440EP Nand flash Problem

U-Boot-Users Bradley Remedios 1 participant 1 message Feb 15, 2005

lore
Share & tools
lore
#0 lore raw

Hello All,

I am having a rather curious problem with using NAND flash on the AMCC 440EP.

My platform boots entirely from NAND Flash, as such, I have modified U-Boot to run from SDRAM and created a small Bootloader that initializes the board and loads U-Boot from NAND to SDRAM where it sets U-Boot running.

I've gotten it to a state where I can load U-Boot via a debugger (RiscWatch) into SDRAM and program NAND with both my small bootloader and U-Boot. This all works.

Now when U-Boot is loaded from NAND to SDRAM using a small bootloader it cannot read the Manufacturer or Chip ID from the NAND flash chip so it bails out. This does not happen when loading the exact same U-Boot image from the RiscWatch to SDRAM and running it.

Using a LogicAnalyzer, I have narrowed down the problem to something that has me stumped that I hope someone here can help me with or point me in the right direction.

The Code in common/cmd_nand.c that identifies the chip basically does the following:

Resets NAND.
Waits for NAND to become READY
Write READ ID Command
Writes Address byte 0
Read Manfacturer ID
Read Chip ID

When loaded under the RiscWatch we see the following:
CLE pulses as WE pulses [Reset of NAND Chip] READY goes low
READY goes high (approx 120ns after going low) CLE pulses as WE pulses [READ ID Command] ALE pulses as WE Pulses [Write Address byte 0] 2 Read Pulses

This is as expected and all works.

When loaded under the bootloader from NAND we see the following:
4 Read Pulses
CLE pulses as WE pulses [Reset of NAND Chip]
READY goes low
READY goes high (approx 120ns after going low)
CLE pulses as WE pulses [READ ID Command]
ALE pulses as WE Pulses [Write Address byte 0]

This is un-expected and does not work. I did not expect the 4 read pulses, and there are absolutly no read pulses (like the 2 expected) after we write the address byte 0.

Does anyone have any ideas as to what could be going wrong? Any help is greatly appreciated.

Signature · 2 lines
Bradley Remedios
bremedios at gmail.com