Skip to contentSkip to conversation

Issues running ust 2.1.0 as non root user

DISCUSSION David Goulet 1 participant 1 message Jan 11, 2013 1 message not in the archive

lore
Share & tools
lore
#1 lore raw
In reply to a message not in the archive

Hi Aaron,

You will have to provide the verbose logs of the session daemon. So, quite simple, start in an other console the session daemon with your user like so:

$ lttng-sessiond -vvv --verbose-consumer > /tmp/sessiond.log

And do the "lttng" commands again. It's going to be quite easier to identify the problem.

A Fatal error of the session daemon, I suspect something is not right with the installation or you are missing memory which I doubt :).

Thanks!
David

Aaron Spear:

Quoted 30 lines

Hi all,

I have LTTng 2.1.0 that I built/installed from source, and it all works fine when I run as root. So as root I can take kernel traces and also ust traces. However, when I attempt to run UST as a normal user it seems that there is some issue with the session daemon that I am not quite understanding. It looks like the permissions are correct on the executables in /usr/local/bin and such. Here is the error that I see with the verbose flag on (not sure if this helps...)

aspear@aspear-deb64 ~

$ lttng --verbose create mytest
DEBUG3: URI string: file:///home/aspear/lttng-traces/mytest-20130111-093135 [in uri_parse() at uri.c:253]
DEBUG3: URI file destination: /home/aspear/lttng-traces/mytest-20130111-093135 [in uri_parse() at uri.c:290]
DEBUG3: URI dtype: 3, proto: 0, host: , subdir: , ctrl: 0, data: 0 [in uri_parse() at uri.c:467]
DEBUG1: LSM cmd type : 8 [in send_session_msg() at lttng-ctl.c:259]
Session mytest created.
Traces will be written in /home/aspear/lttng-traces/mytest-20130111-093135
DEBUG1: Init config session in /home/aspear [in config_init() at conf.c:294]

aspear@aspear-deb64 ~

$ lttng --verbose enable-event -a -u
DEBUG1: Session name found: mytest [in get_session_name() at utils.c:51]
DEBUG1: LSM cmd type : 6 [in send_session_msg() at lttng-ctl.c:259]
Error: Events: Fatal error of the session daemon (channel channel0, session mytest)
DEBUG1: Clean exit [in clean_exit() at lttng.c:169]

Is there perhaps some other setup step required when you do the install from source that the install does for a normal user?

thanks,
Aaron Spear

_______________________________________________
lttng-dev mailing list
[email protected]
http://lists.lttng.org/cgi-bin/mailman/listinfo/lttng-dev