Skip to contentSkip to conversation

Packet size s on CCID3

dccp Sally Floyd 1 participant 1 message Sep 24, 2006

lore
Share & tools
lore
#0 lore raw

I am forwarding this email that I sent earlier - I was using a new email address that wasn't subscribed to the mailing list.

Begin forwarded message:

Quoted 23 lines
Quoted 2 lines

Why not just calculate a packet rate per second? Or am I missing something obvious?

No, that is a good question.

One reason for including the packet size s is discussed in Section 5.3 of RFC 4342:

"The packet size s is used in the TCP throughput equation. A CCID 3 implementation MAY calculate s as the segment size averaged over multiple round trip times -- for example, over the most recent four loss intervals, for loss intervals as defined in Section 6.1. Alternately, a CCID 3 implementation MAY use the Maximum Packet Size to derive s. In this case, s is set to the Maximum Segment Size (MSS), the maximum size in bytes for the data segment, not including the default DCCP and IP packet headers. Each packet transmitted
then
counts as one MSS, regardless of the actual segment size, and the
TCP
throughput equation can be interpreted as specifying the sending
rate
in packets per second."

Quoted 10 lines

Thus, an implementation MAY calculate the allowed sending rate in bytes per second, using for s the average segment size. Or an implementation may use the MSS for s, and in fact calculate the allowed sending rate simply in packets per second. This would be a purely local implementation decision.

- Sally
http://www.icir.org/floyd/

- Sally
http://www.icir.org/floyd/