Skip to contentSkip to conversation

2.6.9-rc1-mm4

DISCUSSION Paul Blazejowski 3 participants 3 messages Sep 9, 2004

lore
Share & tools
lore
#0 lore raw

Andrew,

IT8212 driver fails to recognize RAID0 setup. The driver is built in as module (it8212).

The drives are WDC 120gigers on primary channel as master/slave configured for RAID0.

Quoted 1 line

From dmesg:

IT8212: IDE controller at PCI slot 0000:01:0c.0
ACPI: PCI Interrupt Link [APC2] enabled at IRQ 17
ACPI: PCI interrupt 0000:01:0c.0[A] -> GSI 17 (level, high) -> IRQ 17
IT8212: chipset revision 16
IT8212: 100% native mode on irq 17

    ide2: BM-DMA at 0x9800-0x9807, BIOS settings: hde:DMA, hdf:pio
it8212: controller in RAID mode.
    ide3: BM-DMA at 0x9808-0x980f, BIOS settings: hdg:pio, hdh:pio

Probing IDE interface ide2...
hde: Integrated Technology Express Inc, ATA DISK drive ide2 at 0x8810-0x8817,0x8c02 on irq 17
hde: max request size: 128KiB
hde: 0 sectors (0 MB), CHS=0/0/0
hde: cache flushes not supported
hde: INVALID GEOMETRY: 0 PHYSICAL HEADS? Probing IDE interface ide3...

lsmod shows:

it8212 6336 0 [permanent]

lspci -v:

01:0c.0 RAID bus controller: Integrated Technology Express, Inc. IT/ITE8212 Dual channel ATA RAID controller (PCI version seems to be IT8212, embedded seems (rev 10)

        Subsystem: Integrated Technology Express, Inc.: Unknown device 0001
        Flags: bus master, 66Mhz, medium devsel, latency 0, IRQ 17
        I/O ports at 8810 [size=8]
        I/O ports at 8c00 [size=4]
        I/O ports at 9010 [size=8]
        I/O ports at 9400 [size=4]
        I/O ports at 9800 [size=16]
        Expansion ROM at <unassigned> [disabled] [size=128K]
        Capabilities: [80] Power Management version 2

The board is Gigabyte GA-7NNXP.

Under mm3 kernel, RAID0 was working when using the now dropped iteraid driver.

Paul

Signature · 1 line
FreeBSD the Power to Serve!
#1 lore raw
Quoted 4 lines · Paul Blazejowski

IT8212 driver fails to recognize RAID0 setup. The driver is built in as module (it8212).

OK, there may be some magic to getting it to work. Alan will know.

Quoted 4 lines

...

Under mm3 kernel, RAID0 was working when using the now dropped iteraid driver.

The patch will still apply - ftp://ftp.kernel.org/pub/linux/kernel/people/akpm/patches/2.6/2.6.9-rc1/2.6.9-rc1-mm3/broken-out/iteraid.patch

#2 lore raw
In reply to Paul Blazejowski
Quoted 2 lines · Paul Blazejowski

IT8212 driver fails to recognize RAID0 setup. The driver is built in as module (it8212).

You need the -ac patch for this. I depend upon some core IDE fixes that I'm waiting for Bartlomiej to merge in order to do the RAID devices.

Alan