Skip to contentSkip to conversation

urgent SCSI help please

DISCUSSION Stepan Novotill 2 participants 2 messages Oct 1, 2003 SCSI

lore
Share & tools
lore
#0 lore raw

What does this mean in /var/log/messages when I read data from DTF2 tapes?

kernel: sym53c875-1-<5,*>: FAST-20 WIDE SCSI 40.0 MB/s (50.0 ns, offset 8) last message repeated 11706 times
last message repeated 9539 times

Ive swapped out everything including all SCSI components, kernel versions, drivers, everything.

Funny the symbios driver (doesn't matter which flavor) won't load in /etc/modules.conf but will from rc.local on this PE2600 smp machine. There are two of these (HVD) Symbios-8751D cards installed.

Thanks from Stepan

_________________________________________________________________
MSN 8 with e-mail virus protection service: 2 months FREE* http://join.msn.com/?page=features/virus

#1 lore raw
Quoted 8 lines · Stepan Novotill

What does this mean in /var/log/messages when I read data from DTF2 tapes?

kernel: sym53c875-1-<5,*>: FAST-20 WIDE SCSI 40.0 MB/s (50.0 ns, offset 8) last message repeated 11706 times
last message repeated 9539 times

Ive swapped out everything including all SCSI components, kernel versions, drivers, everything.

It means that your driver and the tape drive are constantly performing speed negotiations. Some drivers don't like it when the device initiates speed negotiations (I'm not claiming that the sym drivers is one of those, just that some don't). However, I wouldn't be suprised if the driver is accepting incoming negotiations, but then also initiating a new negotiation cycle itself (I don't know this to be the case, but it wouldn't suprise me too much). Maybe that would cause your tape drive to reissue it's negotiation. Which would cause the driver to reissue its negotiation. Anyway, one thing to check is try making sure that the tape drive isn't initiating speed negotiations. It usually doesn't help at all, and in some cases causes problems for drivers, so best to just leave it off. A lot of devices have a jumper or dip switch somewhere that allows you to disable this. The manuals usually call it Target Initiated SDTR or Target Ininitiated Negotiation or something similar to that.

HTH.

Signature · 4 lines
  Doug Ledford <[email protected]>     919-754-3700 x44233
         Red Hat, Inc.
         1801 Varsity Dr.
         Raleigh, NC 27606