ECP Parallel Port
Hi,
one of VMware users just pointed to me that ECP mode is now broken
in kernel. 2.4.10-ac9 reports correctly:
0x378: FIFO is 16 bytes0x378: writeIntrThreshold is 80x378: readIntrThreshold is 8
parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE,COMPAT,ECP]parport_pc: Via 686A parallel port: io=0x378
while 2.4.12-ac1 (and all following up to and including 2.4.17-rc1) say just:
parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE]parport_pc: Via 686A parallel port: io=0x378
It looks like a bug to me. Is it known problem, or should I look into it more deeply?
Thanks,
Petr Vandrovec [email protected]
Quoted 2 lines · Petr Vandrovec
one of VMware users just pointed to me that ECP mode is now broken
in kernel. 2.4.10-ac9 reports correctly:
You have run into an unfortunate VMware bug. Arguably it's not really their fault; they went by existing behaviour rather than documented behaviour.
Anyhow, the behaviour you are now seeing is the same as the documented
behaviour: ECP mode is only reported _if_ parport will actually use hardware ECP for ECP transfers. Previously, it would report [ECP] even if it knew perfectly well that it had no intention of using it.
This was fixed in order to provide ECP support in the printer driver.
Quoted 2 lines
It looks like a bug to me. Is it known problem, or should I look into it more deeply?
It's no bug in the kernel, really. It is a known problem though. The solution is for VMware to do their own port capabilities detection, since they don't use the kernel for actually using the parallel port chip (they just use inb/outb). [Incidentally, I've told them this via their feedback email address, but since I don't own a VMware license I am apparently not entitled to file a bug against VMware.]
The work around is to do one of the following:
a) Don't upgrade your kernel; only use a kernel that VMware have verified works with their product;
b) Take appropriate steps to get the kernel to use ECP mode. This
involves: turning on 'EXPERIMENTAL' driver support, turning on 'Use FIFO/DMA if available', and providing 'irq=auto dma=auto' to the parport_pc module when you load it. You may of course have to provide the actual IRQ line number or DMA channel if they can't be automatically detected.
Be aware that option (b) is the more dangerous: DMA printing has known problems, and so does PIO printing (but to a lesser extent).
Tim.
*/