PWM DMA interface
Hi,
I've been writing a driver that uses the PWM to talk to devices that communicate through a pwm like signal. To achieve this some devices have a dma interface that you can stream data at to the pwm...
We use something similar to this on Raspberry Pi to do audio output, we use the PWM interface to output a 'stream' of audio data which is subsequently filtered (RC filter) to give an audio output.
I was hoping to create a driver that was suitably upstreamable and thought about implementing within the world of the pwm class (and was coming here to ask for guidance). Basically I was thinking about implementing it in as an extension of the pwm class:
Add parameter to config() to enable dma access, this will then create a suitable /dev/pwm_dma0 etc. interface to write data to
Only issue is we have a number of parameters / modes we'd like to support that are likely to be platform specific rather than general:
1) Ability to switch between three different modes:
A) serial mode (where the output is actually just a serialisation of the
fifo data.)
B) two formats of mark space ratio, giving a standard duty cycle or a
distributed mark space
2) Ability to set a 'silence value' i.e. what value you transmit when the fifo runs dry
Whats your take on it? In the end if not I'll implement a pwm_dma driver as a platform device specific to the 2835 device
Thanks
Gordon
Signature · 5 lines
Director of Engineering, Raspberry Pi (Trading) Limited T: +44 (0) 1223 322633 M: +44 (0) 7450 946289 E: [email protected] W: www.raspberrypi.org
Quoted 9 lines · Gordon Hollingworth
Hi,
I've been writing a driver that uses the PWM to talk to devices that communicate through a pwm like signal. To achieve this some devices have a dma interface that you can stream data at to the pwm...
We use something similar to this on Raspberry Pi to do audio output, we use the PWM interface to output a 'stream' of audio data which is subsequently filtered (RC filter) to give an audio output.
What kind of audio data is this? Is it able to play back any arbitrary audio signal?
Thierry
Yes within the limitations of the simple RC filter but basically it's working like a one bit DAC
Gordon
Quoted 17 lines · Thierry Reding
Quoted 11 lines · Gordon Hollingworth
Hi,
I've been writing a driver that uses the PWM to talk to devices that communicate through a pwm like signal. To achieve this some devices have a dma interface that you can stream data at to the pwm...
We use something similar to this on Raspberry Pi to do audio output, we use the PWM interface to output a 'stream' of audio data which is subsequently filtered (RC filter) to give an audio output.
What kind of audio data is this? Is it able to play back any arbitrary audio signal?
Thierry
Quoted 2 lines · Gordon Hollingworth
Yes within the limitations of the simple RC filter but basically it's working like a one bit DAC
Perhaps a better way to expose this, then, would be as a proper sound device so that the standard ALSA tools can be used to play back audio rather than needing a set of custom tools.
Thierry
Quoted 9 lines · Thierry Reding
Quoted 2 lines · Gordon Hollingworth
Yes within the limitations of the simple RC filter but basically it's working like a one bit DAC
Perhaps a better way to expose this, then, would be as a proper sound device so that the standard ALSA tools can be used to play back audio rather than needing a set of custom tools.
Thierry
Yes, although it would be better to expose the PWM DMA interface through a PWM class and then implement an ALSA driver on top of this rather than just hacking in a Pi specific pwm driver...
Mostly because I want to write a different driver that uses the PWM DMA interface on the Pi but it seems wrong to do this without having a common PWM_DMA interface
Gordon