Skip to contentSkip to conversation

porting u-boot

U-Boot-Users 吴兵 2 participants 2 messages Sep 27, 2004

lore
Share & tools
lore

吴兵

author
#0 lore raw

HELLO EVERYONE
i am porting u-boot to my hardware my arm is philips lpc2210 . in the readme ,i find that " 1. Add a new configuration option for your board to the toplevel
"Makefile" and to the "MAKEALL" script, using the existing"
i don't understand this sentence. my arm is arm7-tdmi. i use the "S3C44B0 Systems" in in the Makefile, i add some lines as following.but i don't understand what means? is it right?
:#########################################################################
## LPC2210 Systems

B2_config : unconfig

	@./mkconfig $(@:_config=) arm LPC2210 B2 dave

-----------------------------------------------------

#1 lore raw
Quoted 4 lines · In message <[email protected]> you wrote:

i am porting u-boot to my hardware my arm is philips lpc2210 . in the readme ,i find that " 1. Add a new configuration option for your board to the toplevel
"Makefile" and to the "MAKEALL" script, using the existing"
i don't understand this sentence. my arm is arm7-tdmi. i use the "S3C44B0 Systems" in in the Makefile, i add some lines as following.but i don't understand what means? is it right?

I'm sorry. But this will not work. Please stop posting two messages with questions for every single line of code you write.

Please try to get some understanding first. If you don't succeed, then tryu to get some training for such work, or hire a guru.

We will NOT explain you every single line of code here.

Wolfgang Denk

Signature · 4 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd at denx.de
Quote from the Boss... "I didn't say it was your fault.  I said I was
going to blame it on you."