Skip to contentSkip to conversation

AT91 Parallel I/O Controller

PATCH In review Filip Navara 1 participant 1 message Jul 15, 2009

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 6/14 AT91 Parallel I/O Controller

This patch implements the GPIO controller used in the AT91 microcontrollers.

PIO controller is implemented as a device on the system bus with 3 sets of 32 input/output pins and one IRQ pin. The first set of the 32 I/O pins is used for connections to external devices and the other two are used for pass-through connections of external pins to internal peripherals.

Internal pull-up resistors are implemented by simulating the input value of 1 for every input pins where the value of the pin is unknown (a device is not connected) or where explicit -1 constant was sent by the external device emulation (a device is connected, but the wire is not) on the GPIO pin.

Unimplemented features are correct emulation of open-drain mode and glitch-filter.

---
 Makefile.target |    2 +-
 hw/at91_pio.c   |  322 +++++++++++++++++++++++++++++++++++++++++++++++++++++++
 2 files changed, 323 insertions(+), 1 deletions(-)
 create mode 100644 hw/at91_pio.c
Makefile.target +1 -1
index 5501371..5b1f35a 100644
@@ -666,7 +666,7 @@ obj-y += framebuffer.o
 obj-y += syborg.o syborg_fb.o syborg_interrupt.o syborg_keyboard.o
 obj-y += syborg_serial.o syborg_timer.o syborg_pointer.o syborg_rtc.o
 obj-y += syborg_virtio.o
-obj-y += at91_aic.o at91_dbgu.o at91_pmc.o
+obj-y += at91_aic.o at91_dbgu.o at91_pio.o at91_pmc.o
 obj-y += gpio_rotary.o gpio_keypad.o
 CPPFLAGS += -DHAS_AUDIO
 endif
hw/at91_pio.c new file +322 -0

322 lines not on this page · raw message

Signature · 1 line
1.6.3.msysgit.0