Skip to contentSkip to conversation

Kernel Panic during memcpy_toio to PCI card

DISCUSSION Donepudi, Suneeta 1 participant 1 message Nov 1, 2002

lore
Share & tools
lore
#0 lore raw

Hi,

I would like help in diagnosing a kernel panic while accessing a PCI device.

Everything runs fine for sometime and in about 1/2 hour I get a Kernel Panic message saying :

"Unable to handle kernel paging request at virtual address 0xc2821000"

Analysis with Ksymoops shows that it is happening during a memcpy_toio() with the PCI card. The PCI card uses three Base Address Registers with virtual addresses mapped as follows (after ioremap has been issued):

BAR0 = 0xc280f000
BAR1 = 0xc2811000
BAR2 = 0xc2822000

It seems like the kernel panic is complaining about an address which is a combination of BAR1 (lower bytes) and BAR2 (upper bytes). It should really be accessing the BAR1 address at the point the crash occurred.

I put the following if-statement just before the memcpy_toio():
-----------------------------------------------------------
if (((long int)pci_bar1) == 0xc2821000)

{
	printk (KERN_ERR "Illegal address for BAR1\n");
	return -1;
}

memcpy_toio (pci_bar1, in_ptr, len);
------------------------------------------------------------

It still caused the crash in the same manner and at the same location. Could someone help me with pointers to where I should start looking ? Disabling interrupts around the memcpy_toio() did not make any difference. Is this a hardware problem with the PCI card ? We are using a Xilinx core with out FPGA build into it.
Is there a book I could read to learn more about debugging this in the Kernel ?

Thanks a bunch,
Suneeta