Skip to contentSkip to conversation

question about lvm

linux-lvm Andrew Sutton 2 participants 2 messages Sep 2, 1999

lore
Share & tools
lore
#0 lore raw

i'm not really certain if this is the appropriate place to air a question about lvm problems, but since i couldn't find any other documented support - i figured i'd just go to the source.

i'm fairly new at using lvm (yesterday) so this is probably just a newbie question... anyway, i installed lvm, rebuilt my kernel (with lvm in the kernel), compiled the utilities, the whole thing. i then proceeded to drop 2 pv's into a volume group (vda) and allocate one logical volume (lvol1) consisting of all my disk space. and it worked (at which point i was ecstatic). so i built an ext2fs on the lv and mounted it, and again it worked fine. i then put a line in my fstab to mount it on boot, and rebooted.

when the machine came back up, the drive was not mounted. when i tried mounting it by hand, i kept getting a "/dev/vda/lvol1 is not a valid block driver" error. using some of the lvm utils, i uncovered the fact that the entire volume group was "inactive".

i'm not entirely certain what went wrong or where, but i couldn't find any documentation about this particular problem. does anybody have any idea where i might have gone wrong?

thanks in advance,

-------------------
Andrew Sutton
[email protected]

#1 lore raw
Quoted 14 lines

i'm not really certain if this is the appropriate place to air a question about lvm problems, but since i couldn't find any other documented support - i figured i'd just go to the source.

i'm fairly new at using lvm (yesterday) so this is probably just a newbie question... anyway, i installed lvm, rebuilt my kernel (with lvm in the kernel), compiled the utilities, the whole thing. i then proceeded to drop 2 pv's into a volume group (vda) and allocate one logical volume (lvol1) consisting of all my disk space. and it worked (at which point i was ecstatic). so i built an ext2fs on the lv and mounted it, and again it worked fine. i then put a line in my fstab to mount it on boot, and rebooted.

Quoted 4 lines

when the machine came back up, the drive was not mounted. when i tried mounting it by hand, i kept getting a "/dev/vda/lvol1 is not a valid block driver" error. using some of the lvm utils, i uncovered the fact that the entire volume group was "inactive".

you have to insert a "vgscan" and a "vgchange -ay" into your startup files (see step 9 in file INSTALL in the LVM source top directory)

Quoted 5 lines

i'm not entirely certain what went wrong or where, but i couldn't find any documentation about this particular problem. does anybody have any idea where i might have gone wrong?

Regards,
Heinz

--

=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-

Systemmanagement CS-TS T-Nova
Entwicklungszentrum Darmstadt
Heinz Mauelshagen Otto-Roehm-Strasse 71c
Senior Systems Engineer Postfach 10 05 41

                                                 64205 Darmstadt
[email protected]                      Germany
                                                 +49 6151 886-425
                                                          FAX-386

=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-