#yocto eth0 stays down if enp1s0 is renamed in zeus
Hi,
moving from thud to zeus eth0 no longer goes up on boot.
The device has two ethernet ports eth0 and enp1s0. The image renames enp1s0 to eth1 which works fine in thud using:
# cat /etc/systemd/network/50-eth1.link [Match] Driver=igb Path=platform-1ffc000.pcie-pci-0000:01:00.0
[Link]
Name=eth1
Additionally there are two config files to set eth0 to dhcp and eth1 to 192.168.3.1. These i had to rename to precede the new default config file in zeus named /lib/systemd/network/80-wired.network If i deactivate the link file both ethernet ports work just fine in zeus too. As soon as the link-file is active enp1s0 is renamed to eth1 and eth0 stays down.
# networkctl list -a IDX LINK TYPE OPERATIONAL SETUP 1 lo loopback carrier pending 2 eth0 ether off pending 3 eth1 ether no-carrier configured 4 sit0 sit off pending
A cable is connected to eth0 and there is none on eth1. (It is possible to bring eth0 up manually.) I red something about IPv6 problems but enabling/disabling brought no change.
The status of systemd-networkd is active (running)
The status of systemd-networkd-wait-online is Active: failed
Any help would be great. Thank you
Regards
hu