[QuestionIP_CONFIG : incomplete network configration info...
Hi all developers.
I ported ppcboot, linux kernel and ramdisk. when I boot kernel and ramdisk I got this message..
IP_CONFIG: Incomplete network configuration info
dev_cluse: bug eth0 still running....
but I got linux shell. and all linux function worked fine...... I use ppcboot and HardHat Linux kernel 2.2.14 following list is myboard_config.h
#define CONFIG_ETHADDR 08:00:30:31:32:33 /* Ethernet address */
#define CONFIG_IPADDR 55.121.204.131 /* Target IP address */
#define CONFIG_SERVERIP 55.121.204.174 /* Servier IP address */
#define CONFIG_BOOTDELAY 5 /* autoboot after 5 seconds *
#define CONFIG_BOOTCOMMAND \
"bootp ;" \
"setenv bootargs console=tty0 console=ttyS0 " \
"root=/dev/nfs nfsroot=$(serverip):$(rootpath) " \
"ip=$(ipaddr):$(serverip):$(gatewayip):$(netmask):$(hostname):eth0:off ;" \
"bootm"
I think CONFIG_BOOTCOMMAND is imcomplte.
Could someone describe how to use this BOOTCOMMAND for booting with ramdisk any comments will help me.. thanks.
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
Quoted 2 lines · In message <H00002af04ab19e3@MHS> [email protected] wrote:
Hi all developers.
I don't think _all_ developers are interested in this.
Please send PPCBoot related messages to the PPCBoot mailing list instead.
Quoted 2 lines
IP_CONFIG: Incomplete network configuration info
dev_cluse: bug eth0 still running....
That means you are passing incomplete network configuration to the kernel.
Quoted 6 lines
#define
CONFIG_BOOTCOMMAND\
"bootp ;" \
"setenv bootargs console=tty0 console=ttyS0 " \
"root=/dev/nfs nfsroot=$(serverip):$(rootpath) " \
"ip=$(ipaddr):$(serverip):$(gatewayip):$(netmask):$(hostname):eth0:off ;" \
"bootm"
When the kernel starts, it prints a line with the boot arguments which were passed to it. There must be some parameters missing; probably the "rootpath" environment variable is not set.
Quoted 1 line
I think
CONFIG_BOOTCOMMANDis imcomplte.
No, it it OK. But your BOOTP server configuration in probably incomplete.
Quoted 2 lines
Could someone describe how to use this BOOTCOMMAND for booting with ramdisk any comments will help me.. thanks.
Now when you want to boot with a ramdisk, you definitely DO NOT want to pass "root=/dev/nfs nfsroot=$(serverip):$(rootpath)" as part of the boot arguments!
Try "root=/dev/ram" instead!
Wolfgang Denk
--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: [email protected] Quote from the Boss... "I didn't say it was your fault. I said I was going to blame it on you."
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/