Skip to contentSkip to conversation

Wireguard Dynamic ARP entries

DISCUSSION Diyaa Alkanakre 2 participants 2 messages Aug 19, 2023 – Aug 23, 2023

lore
Share & tools
lore
#0 lore raw

Hello everyone,

I am seeing lots of ARP dynamic entries on Windows when typing "arp -a" on the command line on windows. I am wondering if that is a normal behavior? when I set a wireguard peer with a default route "0.0.0.0/0, ::/0" I end up spending about 2 minutes to get to the bottom of the CLI when I type "arp -a".

I am just wondering if that is a normal behavior? why is this happening??

Thank you in advance,

Diyaa

#1 lore raw

I guess it is a normal thing on windows as Cisco VPN Client works the same way.

--
Endre

Quoted 9 lines · On August 19, 2023 22:31:33 Diyaa Alkanakre <[email protected]> wrote:

Hello everyone,

I am seeing lots of ARP dynamic entries on Windows when typing "arp -a" on the command line on windows. I am wondering if that is a normal behavior? when I set a wireguard peer with a default route "0.0.0.0/0, ::/0" I end up spending about 2 minutes to get to the bottom of the CLI when I type "arp -a".

I am just wondering if that is a normal behavior? why is this happening??

Thank you in advance,

Diyaa