Kernel compile problem after reboot
I am using Slack 8 with 2.2.19 and trying to install 2.4.17. The whole compile process goes as planned until I reboot. After reconfiguring lilo.conf and running lilo to update changes, I reboot and when I select the new kernel all I get is
Loading Linux........................
Then my computer reboots and this continues to do the same until I select the old kernel and it reboots fine.
Did I do something wrong in lilo? I merely made a duplicate entry with a different image= and label= entry:
image = /boot/vzlinuz-2.4.17
root = /dev/hda5
label = Linux_2.4.17
read-only
I perform the standard:
make mrproper
make menuconfig
make dep && make bzImage && make modules &&
make modules_install
cp System.map to /boot
cp bzImage to /boot
edit lilo.conf
run lilo
reboot
swear at the computer.
The compile is clean from what I can see - no error messages. The menuconfig part is all defaults (just trying to get it to reboot at this point).
Any advice would be better than what i've got and would be much appreciated.
J.S.Souza
Quoted 22 lines · J.S.Souza
Date: Tue, 19 Feb 2002 07:47:54 -0800
From: J.S.Souza <[email protected]>
To: [email protected]
Subject: Kernel compile problem after rebootI am using Slack 8 with 2.2.19 and trying to install 2.4.17. The whole compile process goes as planned until I reboot. After reconfiguring lilo.conf and running lilo to update changes, I reboot and when I select the new kernel all I get is
Loading Linux........................
Then my computer reboots and this continues to do the same until I select the old kernel and it reboots fine.
Did I do something wrong in lilo? I merely made a duplicate entry with a different image= and label= entry:image =
/boot/vzlinuz-2.4.17
root =/dev/hda5
label = Linux_2.4.17
read-only
Quoted 12 lines
I perform the standard:
make mrproper
make menuconfig
make dep && make bzImage && make modules &&
makemodules_install
cp System.map to /boot
cp bzImage to /boot
edit lilo.conf
run lilo
reboot
swear at the computer.
do configure the kernel! Do not use defaults!
when you did cp bzImage to /boot
I hope you did cp bzImage /boot/vzlinuz-2.4.17
then try this cp bzImage /dev/fd0
rdev /dev/fd0 /dev/hda5
try to boot from floppy
if that is ok , reconfigure kernel try to boot it. If it still don't boot perhaps your bios can't reach kernel for some reason.
if still don't work post description on what hardware / disk ?
regards,
Zoran