problem in booting HP zx6000 with stock kernel 2.5.75
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 1 line
Quoted 1 line
Quoted 1 line
Quoted 1 line
Quoted 1 line · Noida
Deepak> Hello everybody I am trying to boot 2 CPU hp zx6000 machine Deepak> (ia64, itanium2) from STOCK kernel version 2.5.75. I have Deepak> followed following steps.
2.5.75? Why such an old kernel?
Deepak> Kindly provide me appropriate guidance.. , where am I wrong?
For a zx6000, you're better off configuring it as ZX1 system, rather than GENERIC. The latter should also work, but will be (slightly) less efficient (and the kernel will be needlessly bigger).
Deepak> I have following doubts: -
Deepak> 1. Is it possible to build and run _stock_ kernel (not Deepak> redhat patched kernel, as redhat advanced distribution is Deepak> available on my machine) on hp zx6000 machine ?
Yes, but you do need something newer than 2.5.75. Try 2.6.0-test9.
Deepak> Do I need additional patches the stock kernel + ia64 patch ?
No patch is needed. There still is a patch, but if you don't care about the last drop of performance and/or early printk-support, you don't need it.
BTW: The daily build-status of Linus' kernel tree can be found here:
http://www.gelato.unsw.edu.au/kerncomp/
You can also get know-to-be-good .config files from there.
Also, in the future you may want to use [email protected] for such question, since that mailing list is focused on ia64.
--david