2.4.9 to 2.4.14 bug & workaround
Hmm,
Quoted 4 lines
Quoted 2 lines
Device Boot Start End Blocks Id System
/dev/sdb41 1536 98288 6 FAT16.which is evidently there?
I found out some of my disks have no partition table 'readable by Linux'. Which is really f***** weird since, they can be read under NT. What is also really weird is that some of these disks can be mounted as /dev/hdd4 even though there is no valid partition.
In some cases these are zip disks that were readable under 2.2.x, but since I don't have 2.2.x anymore I cannot verify that they would still be readable. Rather strange that a disk partition would just disapear like that. Unless the drive itself is hiding it or not recgonizing it.
In any case it seems if I run fdisk against the disks and then mformat they behave better. But aren't zip disks formated and partitioned out of the box? These ones all were.
Quoted 5 lines
Quoted 2 lines
Until now I thought it had something to do with the different gendisk, LDM or so.
Well, you may also see firmware and/or design flaws in the drive (personally, I have never trusted iomega, because on the CeBIT fair in
Mine is not an 'iomega' drive, but a copy. Made by someone else. AFAIK.
Quoted 3 lines
Hannover, I once asked them "why should I prefer iomega ZIP or JAZ over SyQuest" and they had no answer except "we're just better". I later heard complaints about the SCSI ID only to be chosen from 5 or 6,
25-pin
I got mine cause it was cheap, internal and I already had zip disks.
Quoted 3 lines
Judging from what's on that page, the IDE driver seems to know it's >just a "floppy" without partitions, but the USB driver sees the (fake) partitions.
This would explain what I am seeing, weird as it may seem. I used to be using an external iomega zip drive that recgonized these disks, but now the internal one does not seem to.
I guess this means that I have to run fdisk on all these disks. Then mformat.
Hmm, it would be nice if there was a workaround.
Joe