Skip to contentSkip to conversation

block ioctl to read/write last sector

DISCUSSION [email protected] 2 participants 2 messages Feb 13, 2001 – Feb 14, 2001

lore
Share & tools
lore
#0 lore raw

From [email protected] Wed Feb 14 00:37:25 2001

> Look at the addpart utility in the util-linux package. > It will allow you to add a partition disjoint from > previously existing partitions.
> And since a partition can start on an odd sector, > this should allow you to also read the last sector. >
> Do I overlook something?

Yes. The addpart utility just uses the block-layer ioctls to dynamically add and/or remove partitions. What this is doing is just adjusting the kernel's idea of what the current partition scheme is. This has _nothing_ to do with actually reading or writing data from the disk.

But it changes the idea of odd and even.
A partition can start on an odd sector.

Andries

#1 lore raw
Quoted 3 lines · On Wed, 14 Feb 2001 [email protected] wrote:

But it changes the idea of odd and even.
A partition can start on an odd sector.

That is orthogonal to the issue that I am trying to solve with my patch. My code is trying to make it possible to access sectors at the _end_ of the disk that you cannot access any other way. Example:

Disk with 1001 blocks. Hardware 512-byte sector size. The block layer uses 1024-byte soft blocksize. This means that, at the _end_ of the disk there is a single sector that represents half of a software sector. The block layer will not normally let you read or write that sector because it is not a full sector.

Another example: Disk with 7 blocks (very small disk :-). Hardware blocksize=512, Block layer uses 4096-byte blocksize. Now you have _three_ hardware blocks at the end of the disk that the block layer will not let you read or write.

My patch allows an alternate method to access these sectors. My patch has nothing to do with partitioning.

--
Michael Brown
Linux Systems Group
Dell Computer Corp