Skip to contentSkip to conversation

block ioctl to read/write last sector

DISCUSSION [email protected] 2 participants 3 messages Feb 14, 2001

lore
Share & tools
lore
#0 lore raw
Quoted 1 line

My patch has nothing to do with partitioning.

Yes, you already said that, and I understand you very well. My suggestion, and I have not checked the code to make sure, but off-hand it seems to me that it should work, is to use a partition.

Quoted 4 lines

Disk with 1001 blocks. Hardware 512-byte sector size. The block layer uses 1024-byte soft blocksize.
This means that, at the _end_ of the disk there is a single sector that represents half of a software sector.

Maybe. I think that you'll find that these blocks are relative to the start of the partition, not relative to the start of the disk.

So if you add a 1-block partition that contains the last sector of the disk, all should be fine.

Andries

#1 lore raw
Quoted 4 lines · On Wed, 14 Feb 2001 [email protected] wrote:

So if you add a 1-block partition that contains the last sector of the disk, all should be fine.

Oh! I didn't get your meaning before. I think I understand now. The problem with this is that the tests for block writeability are not done on a per-partition basis. They are done on a whole block device basis. see fs/block_dev.c in block_read() and block_write(). The following test kills us:

        if (blk_size[MAJOR(dev)])
                size = ((loff_t) blk_size[MAJOR(dev)][MINOR(dev)] <<
BLOCK_SIZE_BITS) >> blocksize_bits;
        else
                size = INT_MAX;
        while (count>0) {
                if (block >= size)
                        return written ? written : -ENOSPC;

--
Michael Brown
Linux Systems Group
Dell Computer Corp

#2 lore raw
In reply to [email protected]
Quoted 8 lines · On Wed, 14 Feb 2001 [email protected] wrote:

Maybe. I think that you'll find that these blocks are relative to the start of the partition, not relative to the start of the disk.

So if you add a 1-block partition that contains the last sector of the disk, all should be fine.

Ok. Upon re-reading the code in question, I was too hasty in my assumptions. This might work, so I'll try it. I don't expect it to be awfully pretty, though :-(

--
Michael Brown
Linux System Group
Dell Computer Corp