Skip to contentSkip to conversation

syscall documentation (3)

DISCUSSION [email protected] 2 participants 2 messages Feb 6, 2003

lore
Share & tools
lore
#0 lore raw

The next new page is tkill.2

Comments welcome.
Andries
[email protected]

-----------------------------------
NAME
tkill - send a signal to a single process

SYNOPSIS

       #include <sys/types.h>
       #include <linux/unistd.h>

       _syscall2(int, tkill, pid_t, tid, int, sig)

       int tkill(pid_t tid, int sig);

DESCRIPTION
The tkill system call is analogous to kill(2), except when the specified process is part of a thread group (created by specifying the CLONE_THREAD flag in the call to clone). Since all the processes in a thread group have the same PID, they cannot be individually signalled with kill. With tkill, however, one can address each process by its unique TID.

RETURN VALUE
On success, zero is returned. On error, -1 is returned, and errno is set appropriately.

ERRORS
EINVAL An invalid TID or signal was specified.

ESRCH No process with the specified TID exists.

EPERM The caller did not have permission to send the sig�
nal to the specified process. For a process to be allowed to send a signal, it must either have root privileges, or its real or effective user ID must be equal to the real or saved set-user-ID of the receiving process.

CONFORMING TO
tkill is Linux specific and should not be used in programs that are intended to be portable.

SEE ALSO

       gettid(2), kill(2)

Linux 2.4.20 2003-02-01 TKILL(2)

#1 lore raw
Quoted 9 lines · On Thu, Feb 06, 2003 at 09:09:24PM +0100, [email protected] wrote:

The next new page is tkill.2

Comments welcome.
Andries
[email protected]

-----------------------------------
NAME
tkill - send a signal to a single process

Shouldn't kill and tkill be in one manpoage that documents both?