Skip to contentSkip to conversation

BOOTP Standalone Floppy Boot (2.4.13pre6)

PATCH In review Andreas Steinmetz 2 participants 2 messages Oct 23, 2001

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 BOOTP Standalone Floppy Boot (2.4.13pre6)

If using 2.4.x standalone floppy boot (i.e. dd if=vmlinuz of=/dev/fd0, then booting from this floppy) with a BOOTP/NFS root enabled kernel fails. This behaviour is different from 2.2.x. 2.4.x uses:

__setup("ip=", ip_auto_config_setup);
__setup("nfsaddrs=", nfsaddrs_config_setup);

None of these are called when there are no boot parameters. In case of standalone floppy boot there are NO boot parameters. This results in no BOOTP and NFS root configuration done and thus boot failure.

The fix is to set ic_enable to 1 as the default to get the same beaviour as for 2.2.x.

Andreas Steinmetz
D.O.M. Datenverarbeitung GmbH

net/ipv4/ipconfig.c +1 -1
@@ -100,7 +100,7 @@
  */
 int ic_set_manually __initdata = 0;		/* IPconfig parameters set manually */
 
-int ic_enable __initdata = 0;			/* IP config enabled? */
+int ic_enable __initdata = 1;			/* IP config enabled? */
 
 /* Protocol choice */
 int ic_proto_enabled __initdata = 0
#1 lore raw
Quoted 3 lines

If using 2.4.x standalone floppy boot (i.e. dd if=vmlinuz of=/dev/fd0, then booting from this floppy) with a BOOTP/NFS root enabled kernel fails. This behaviour is different from 2.2.x. 2.4.x uses:

Standalone floppy boot is purely historic interest, and likely to go away Stick lilo or similar on the floppy