drm/bridge: Avoid uninitialized variable warning
Subsystems (4)
PATCH v2 1/1 drm/bridge: Avoid uninitialized variable warning
This code works, but technically it uses "num_in_bus_fmts" before it has been initialized so it leads to static checker warnings and probably KMEMsan warnings at run time. Initialize the variable to zero to silence the warning.
Fixes f32df58acc68 ("drm/bridge: Add the necessary bits to support bus format negotiation")
Signed-off-by Dan Carpenter <[email protected]>
---
v2: initialize the variable instead, this keeps the original error codes.
drivers/gpu/drm/drm_bridge.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
drivers/gpu/drm/drm_bridge.c +2 -2
@@ -846,8 +846,8 @@ static int select_bus_fmt_recursive(struct drm_bridge *first_bridge, struct drm_connector_state *conn_state, u32 out_bus_fmt) { +unsigned int i, num_in_bus_fmts =0 ;struct drm_bridge_state *cur_state; -unsigned int num_in_bus_fmts, i;struct drm_bridge *prev_bridge;u32 *in_bus_fmts;int ret;
@@ -968,7 +968,7 @@ drm_atomic_bridge_chain_select_bus_fmts(struct drm_bridge *bridge,struct drm_connector *conn = conn_state->connector;struct drm_encoder *encoder = bridge->encoder;struct drm_bridge_state *last_bridge_state; -unsigned int i, num_out_bus_fmts; +unsigned int i, num_out_bus_fmts =0 ;struct drm_bridge *last_bridge;u32 *out_bus_fmts;int ret =0 ;
Signature · 1 line
2.35.1
Maxime Ripard
AppliedRe: (subset) [PATCH v2] drm/bridge: Avoid uninitialized variable warning
Quoted 6 lines · Dan Carpenter
This code works, but technically it uses "
num_in_bus_fmts" before it has been initialized so it leads to static checker warnings and probably KMEMsan warnings at run time. Initialize the variable to zero to silence the warning.
Applied to drm/drm-misc (drm-misc-next).
Thanks!
Maxime