hwmon: Add support for the INA260 chip to the INA219 and compatibles driver
PATCH 1/1 hwmon: Add support for the INA260 chip to the INA219 and compatibles driver
This patch allows to retrieve current, bus voltage and power measurements from the INA260 using its default configuration.
As the INA260 provides integrated shunt, the "ishunt" configuration parameter is introduced. As such, proper attributes can be attached with hwmon and shunt calibration related routnies can be ignored. In addition, the actual INA2XX current register address differ from the INA260 as it does not provide a shunt register. Thus, a specific register address INA2XX_CURRENT_ISHUNT for chips with integrated shunts is proposed.
--- drivers/hwmon/Kconfig | 2 +- drivers/hwmon/ina2xx.c | 77 ++++++++++++++++++++++++++++++++++-------- 2 files changed, 64 insertions(+), 15 deletions(-)
drivers/hwmon/Kconfig +1 -1
@@ -2022,7 +2022,7 @@ config SENSORS_INA2XX select REGMAP_I2C help If you say yes here you get support for INA219, INA220, INA226, - INA230, and INA231 power monitor chips. + INA230, INA231 and INA260 power monitor chips. The INA2xx driver is configured for the default configuration of the part as described in the datasheet.
drivers/hwmon/ina2xx.c +63 -14
178 lines not on this page · raw message
Signature · 1 line
2.41.0
Guenter Roeck
maintainerHi,
Quoted 11 lines · Loic Guegan
This patch allows to retrieve current, bus voltage and power measurements from the INA260 using its default configuration.
As the INA260 provides integrated shunt, the "ishunt" configuration parameter is introduced. As such, proper attributes can be attached with hwmon and shunt calibration related routnies can be ignored. In addition, the actual INA2XX current register address differ from the INA260 as it does not provide a shunt register. Thus, a specific register address
INA2XX_CURRENT_ISHUNTfor chips with integrated shunts is proposed.
Quoted 1 line
Signed-off-by Loic Guegan <[email protected]>
This patch will no longer apply after the series at
https://lore.kernel.org/linux-hwmon/[email protected]/T/#t
is accepted and applied. It is also less than perfect since it does not support current limits. Adjusting the driver to support ina260 should be much more straightforward after the above patches are applied. I'll send a follow-up series of patches after I was able to test it with a real chip (I am currently waiting for an evaluation board to arrive).
In case anyone is curious, the (untested) patches necessary to support INA260 are available in the hwmon-staging and testing branches ofgit://git.kernel.org/pub/scm/linux/kernel/git/groeck/linux-staging.git
Guenter