Skip to contentSkip to conversation

intel8x0 mic input even with gain and 100% vol. too quietly

DISCUSSION [email protected] 1 participant 1 message Jul 13, 2002

lore
Share & tools
lore
#0 lore raw

Hi all,

I try to play with my microphone attached to my intel810 soundsystem. But even with 100% mic volume and +20db gain it is too silent. Is this a known

problem of the I810 Chipset ???

Too silent means, I have to blow directly into the mic to hear anything ... normal speak, even cry load doesn't realy help ...

Thanks in advance
Stefan

[root@voyager cvoicecontrol]# cat /proc/asound/cards
0 [card0 ]: ICH - Intel 82801BA-ICH2

                     Intel 82801BA-ICH2 at 0xe000, irq 10

[root@voyager cvoicecontrol]# cat /proc/asound/card0/ac97#0 0-0/0: Avance Logic ALC200/200P rev 0

Capabilities : -headphone out-
DAC resolution : 18-bit
ADC resolution : 18-bit
3D enhancement : Realtek 3D Stereo Enhancement

Current setup
Mic gain : +20dB [+20dB]
POP path : pre 3D
Sim. stereo : off

3D enhancement   : on
Loudness         : off
Mono output      : MIX
Mic select       : Mic1

ADC/DAC loopback : off
Extended ID : codec=0 rev=1 AMAP DSA=0 SPDIF VRA
Extended status : SPCV SPDIF=3/4 VRA
PCM front DAC : 48000Hz
PCM ADC : 48000Hz
SPDIF Control : Consumer PCM Copyright Category=0x2 Generation=1
Rate=48kHz

-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Welcome to geek heaven.
http://thinkgeek.com/sf