Skip to contentSkip to conversation

CAN Utils

DISCUSSION Kurt Van Dijck 1 participant 1 message Jul 18, 2014 1 message not in the archive CAN network drivers

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): ahafkglomfqdhtkargpl@sawx

#1 lore raw
Quoted 7 lines · Jan Kinkazu

Hi Kurt.

Sorry for botherring you on your private email, but I don't know which forum to join to have a contact with you.

I would like to ask you 2 questions regardig your J1939 stack and can utils.

Quoted 8 lines

I have very very limited knowledge how CAN or J1939 works, but I was able to include your patch to kernel, install iproute with your commits, install your can-j1939-utils.

The first question is:

Do I need your J1939 stack if the only think I want to do is receive data from the J1939 engine?

If you want to seamlessly use transport protocol,
you could use my J1939 stack.
dynamic addressing (address claiming) is probably not usefull since engine controllers sit on 0x00.

Quoted 3 lines

I have both can-utils and can-J1939-utils and candump shows exactly the same info.

can-j1939-utils is can-utils + some j1939 specific tools. candump is supposed to work exactly the same.

Quoted 4 lines

The second question is:

Why cansniffer shows nothing wile candump shows properly can0 traffic?

I'm not familiar with cansiffer.

Quoted 8 lines

Kind Regards

P.S

If you tell me where, i will post my questions on the forum so everybody can drink from the well of your wisdom

the proper place is [email protected] which I added in CC

Quoted 1 line