Skip to contentSkip to conversation

building a rootfs for a mips SEAD-3, and DEFAULTTUNE

DISCUSSION Robert P. J. Day 2 participants 2 messages Apr 10, 2013

lore
Share & tools
lore
#0 lore raw

my recent curiosity about MIPS was inspired by a former student
asking what it would take to build a root filesystem for the SEAD-3:

http://www.mips.com/products/development-kits/mips-sead-3/

he'd already built for the routerstation pro and, according to him,
the fundamental difference is that rs pro defaults to big endian, while the SEAD-3 is little endian. he already has u-boot and the kernel, he just wanted to build a corresponding rootfs.

after a *very* cursory glance at the layers, i suggested that it
looked like all he had to do was set:

DEFAULTTUNE = "mips32el"

in his local.conf to override the default of "mips32" in the file tune-mips32.inc.

i'm quite prepared to be totally wrong about this, so if someone has
a better answer, i'm open to suggestions.

rday

p.s. i was originally going to suggest the SEAD-3 as the next MIPS board until he told me it cost $2K. ouch.

Signature · 7 lines
========================================================================
Robert P. J. Day                                 Ottawa, Ontario, CANADA
                        http://crashcourse.ca

Twitter:                                       http://twitter.com/rpjday
LinkedIn:                               http://ca.linkedin.com/in/rpjday
========================================================================
#1 lore raw
Quoted 2 lines · Robert P. J. Day

p.s. i was originally going to suggest the SEAD-3 as the next MIPS board until he told me it cost $2K. ouch.

You clearly didn't read the marketing drivel closely enough:

"The MIPS® SEAD™ -3 System engineering and development board is designed to provide a *low-cost* means to support various CPU cores"

:-)