IDE Warning when booting
Hi,
I get these since many 2.4.21-pre<x>-ac<y> versions.
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX3: IDE controller at PCI slot 00:07.1
PIIX3: chipset revision 0
PIIX3: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:pio, hdb:pio
ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, hdd:piohda: QUANTUM BIGFOOT_CY6480A, ATA DISK drive
blk: queue c02d2bc0, I/O limit 4095Mb (mask 0xffffffff)
hdc: IBM-DTLA-307060, ATA DISK drive
blk: queue c02d3018, I/O limit 4095Mb (mask 0xffffffff) ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: attached ide-disk driver.
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv
hda: task_no_data_intr: status=0x51 { DriveReady SeekComplete Error }
hda: task_no_data_intr: error=0x04 { DriveStatusError } ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
hda: 12706470 sectors (6506 MB) w/67KiB Cache, CHS=790/255/63, DMA
hdc: attached ide-disk driver.
hdc: host protected area => 1
hdc: 120103200 sectors (61493 MB) w/1916KiB Cache, CHS=119150/16/63, (U)DMA ide-floppy driver 0.99.newide
Partition check:
hda: hda1 hda2 < hda5 hda6 hda7 hda8 hda9 >
hdc: [PTBL] [7943/240/63] hdc1 < hdc5 hdc6 >
ide-floppy driver 0.99.newide
The kernels itself are not too stable on my trustworthy old PPro 200 box (which runs rock solid with the RedHat 7.3 release kernels). Not too stable means "crashes about every other night".
The is a PPro 200 with 256 MBytes RAM, Tyan Mainboard. Not overclocked, well cooled, lightly loaded. It normally crashes when the only really disk pushing operation (Backup via Amanda) is started at night.
I sent some crash reports to Alan, I will post any with pre7-ac1 here. I got a serial console hooked up to that box and I intent to use it. :-)
Regards
Henning
Signature · 5 lines
Dipl.-Inf. (Univ.) Henning P. Schmiedehausen INTERMETA GmbH [email protected] +49 9131 50 654 0 http://www.intermeta.de/ Java, perl, Solaris, Linux, xSP Consulting, Web Services freelance consultant -- Jakarta Turbine Development -- hero for hire
Quoted 6 lines · Henning P. Schmiedehausen
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv
hda:task_no_data_intr: status=0x51 { DriveReady SeekComplete Error }
hda:task_no_data_intr: error=0x04 { DriveStatusError } ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Not the exact, byte-for-byte, same, but, from Configure.help:
CONFIG_IDEDISK_MULTI_MODE
If you get this error, try to say Y here:
hda: set_multmode: status=0x51 { DriveReady SeekComplete Error }
hda: set_multmode: error=0x04 { DriveStatusError }
If in doubt, say N.
Do you have that option enabled or not?
-Ath
Signature · 4 lines
- Athanasius = Athanasius(at)miggy.org / http://www.miggy.org/
Finger athan(at)fysh.org for PGP key
"And it's me who is my enemy. Me who beats me up.
Me who makes the monsters. Me who strips my confidence." Paula Cole - MEQuoted 6 lines · Athanasius
--ALfTUftag+2gvp1h
Content-Type: text/plain; charset=us-ascii
Content-Disposition: inline
Content-Transfer-Encoding: quoted-printableOn Wed, Apr 16, 2003 at 10:16:12AM +0000, Henning P. Schmiedehausen wrote:
Quoted 8 lines
Quoted 6 lines
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv
hda:task_no_data_intr: status=3D0x51 { DriveReady SeekComplete Error }
hda:task_no_data_intr: error=3D0x04 { DriveStatusError } ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!Not the exact, byte-for-byte, same, but, from Configure.help:
Alan did post an explanation for these (which I haven't read before posting this) that these are harmless. And yes, the task_no_data_intr vs. set_multmode makes all the difference. :-) Getting these quieted down would be nice, though.
Regards
Henning
Signature · 5 lines
Dipl.-Inf. (Univ.) Henning P. Schmiedehausen INTERMETA GmbH [email protected] +49 9131 50 654 0 http://www.intermeta.de/ Java, perl, Solaris, Linux, xSP Consulting, Web Services freelance consultant -- Jakarta Turbine Development -- hero for hire