Diskonchip MD2200-D16 redhat installation

How do I install a minimal redhat 7.2 on the DiskonChip (16mb) to load a 1mb application.
Urls as references highly welcomed

basically the best place to start is the 'howto boot disk' this will tell you exactly how to build a linux boot for a floppy disk, the principles for building on be it flash or harddrive is exactly the same, infact i returned to this website quite a few times,

http://www.tldp.org/HOWTO/Bootdisk-HOWTO/

just for testing build a 2 part floppy disk, one with kernel and one with root and practise booting it from the floppy disk,

i think the best way tho is to prepare the DOC with jffs then i assume you can build your root fs and kernel on it and not worry too much about power down etc?

regards stephen
----- Original Message -----
From: "sam Njengah" <[email protected]>
To: <[email protected]>
Sent: Wednesday, July 02, 2003 4:07 AM
Subject: Diskonchip MD2200-D16 redhat installation

1mb

________________________________________________________________________
This e-mail has been scanned for all viruses by Star Internet. The service is powered by MessageLabs. For more information on a proactive anti-virus service working around the clock, around the globe, visit:
http://www.star.net.uk
________________________________________________________________________

That is probably the best way forward, yes. Especially with a 16MiB unit where you really do want the compression.

I committed code to CVS yesterday to make JFFS2 work out of the box on the DiskOnChip 2000 and Millennium (not Millennium Plus). I haven't tested it hard yet, though.

dwmw2