QinQ strip not working on XL710

http://bugs.dpdk.org/show_bug.cgi?id=1926

Bug ID: 1926
Summary: QinQ strip not working on XL710
Product: DPDK
Version: unspecified
Hardware: All
OS: All
Status: UNCONFIRMED
Severity: normal
Priority: Normal
Component: ethdev
Assignee: [email protected]
Reporter: [email protected]
Target Milestone: ---

Packets with a single 88a8 tag, and packets with 88a8 and 8100 tags, are not affected with qinq strip enabled:

testpmd> vlan set qinq_strip on 0
testpmd> vlan set strip on 0

Sent Dot1AD: Ether(src='40:a6:b7:22:b0:18', dst='3c:fd:fe:c8:1a:a8')/Dot1AD()/IP(src='192.168.100.3', dst='192.168.101.3')/UDP(sport=4321, dport=1234)/Raw(load=b'xxxxx')

Received: Ether / Dot1AD / IP / UDP 192.168.100.3:4321 > 192.168.101.3:1234 / Raw / Padding

Sent QinQ: Ether(src='40:a6:b7:22:b0:18', dst='3c:fd:fe:c8:1a:a8')/Dot1AD()/Dot1Q()/IP(src='192.168.100.3', dst='192.168.101.3')/UDP(sport=4321, dport=1234)/Raw(load=b'xxxxx')

Received: Ether / Dot1AD / Dot1Q / IP / UDP 192.168.100.3:4321 > 192.168.101.3:1234 / Raw / Padding

It seems a previous ticket was closed a few years ago without resolution, which outlined the same problem: https://bugs.dpdk.org/show_bug.cgi?id=1122

sudo ethtool -i enp181s0f0np0
driver: i40e
version: 6.8.0-106-generic
firmware-version: 9.55 0x8000fe31 1.3862.0
expansion-rom-version:
bus-info: 0000:b5:00.0
supports-statistics: yes
supports-test: yes
supports-eeprom-access: yes
supports-register-dump: yes
supports-priv-flags: yes

uname -m
x86_64

DPDK version: 26.03 rc2

You are receiving this mail because:
You are the assignee for the bug.

Is this using the i40e or the iavf driver? For iavf driver, these is a patch already upstreamed to enable qinq strip [1].

/Bruce

[1] https://patches.dpdk.org/project/dpdk/patch/[email protected]/