bnxt: rte_eth_stats_get() returning zeros between valid counts
https://bugs.dpdk.org/show_bug.cgi?id=641
Bug ID: 641
Summary: bnxt: rte_eth_stats_get() returning zeros between
valid counts
Product: DPDK
Version: 20.11
Hardware: x86
OS: All
Status: UNCONFIRMED
Severity: normal
Priority: Normal
Component: ethdev
Assignee: [email protected]
Reporter: [email protected]Target Milestone: ---
Created attachment 145
--> https://bugs.dpdk.org/attachment.cgi?id=145&action=edit
testpmd log showing issue
Hello,
I am testing with DPDK-20.11 and a Broadcom P2100G NIC. I observed this problem on FreeBSD-12.2 and Ubuntu 20. My application occasionally reports invalid packet and byte counts. These statistics are obtained from the rte_eth_stats_get() function and my code is checking the return value.
When I added some debugging, I observed that occasionally the ipackets and ibytes fields would be set to zero even though the function call returned zero (success). The calls before and after would have increasing values so it is clear the internal registers weren't reset, just invalid values on this one call. I have also seen this same behavior for the opackets and obytes fields.
The attached testpmd run shows the problem. I show several seconds of stats, then snip to several seconds before the problem occurred. Port 0 showed:
RX-packets: 435792933 RX-missed: 0 RX-bytes: 27890747712
the next second it reported:
RX-packets: 0 RX-missed: 0 RX-bytes: 0
and the following:
RX-packets: 450562244 RX-missed: 0 RX-bytes: 28835983616
The test was running at 7.3Mpps while the difference between the first and last stats output is 14.7Mpps (7.3*2) for a duration of 2s. So I believe the hardware is properly incrementing the counters. It seems like the returned values aren't being set properly under certain conditions. I have reviewed the code but was unable to determine how this could happen.
Signature · 2 lines
You are receiving this mail because: You are the assignee for the bug.