Skip to contentSkip to conversation

about fpga

U-Boot-Users 腾飞龙 3 participants 3 messages Jan 18, 2006

lore
Share & tools
lore

腾飞龙

author
#0 lore raw

Hi,all,

    I'm porting u-boot-1.1.4 to (Embedded Planet)EP405 (with ppc405GPr

processor), As Denk suggested, the esd CPCI4052 board is most similiar to my board. however CPCI4052 has FPGA configuration while my board doesn't have FPGA, so, if i don't consider this difference during the porting procedure because of its complexity, will the u-boot work well? Because i can't debug u-boot now
Thanks and best wishes

#1 lore raw
Quoted 3 lines · In message <[email protected]> you wrote:
    I'm porting u-boot-1.1.4 to (Embedded Planet)EP405 (with ppc405GPr

processor), As Denk suggested, the esd CPCI4052 board is most similiar

I never made such a suggestion.

Quoted 4 lines

to my board. however CPCI4052 has FPGA configuration while my board doesn't have FPGA, so, if i don't consider this difference during the porting procedure because of its complexity, will the u-boot work well? Because i can't debug u-boot now

Of course it cannot work if you try to access a non-existing FPGA.

Porting U-Boot is a complex task, and this complexity cannot be ignored. At least not without consequences ;-)

Best regards,

Wolfgang Denk

Signature · 3 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"I like your game but we have to change the rules."
#2 lore raw
Quoted 5 lines · Wolfgang Denk
Quoted 2 lines · In message <[email protected]> you wrote:
    I'm porting u-boot-1.1.4 to (Embedded Planet)EP405 (with ppc405GPr

processor), As Denk suggested, the esd CPCI4052 board is most similiar

I never made such a suggestion.

Thant was me. IIRC because of the onboard SDRAM setup.

Quoted 6 lines
Quoted 4 lines

to my board. however CPCI4052 has FPGA configuration while my board doesn't have FPGA, so, if i don't consider this difference during the porting procedure because of its complexity, will the u-boot work well? Because i can't debug u-boot now

Of course it cannot work if you try to access a non-existing FPGA.

You have to remove all FPGA replated code in your board port.

Best regards,
Stefan