No luck getting 2.6.x kernel to work with ACPI on compaq laptop
My Compaq presario 700EA locks up dead during boot with
ACPI enabled. With bootoption acpi=off (or not compiled into the kernel) the machine works just fine.
I put on acpi debug and typed over by hand (laptop's dont have serial ports these days anymore) :
ACPI: Subsystem revision 20040326
tbxface-0017[03] acpi_load_tables: ACPI tables succesfully acquired Parsing all Control Methods: [......]
Table [DSDT] (id F005) - 433 Objects with 44 Devices 109 Methods 15 Regions
Parsing all Control Methods:
Table [SSDT] (id f003) - 3 objects with 0 Devices 0 Methods 0 Regions
ACPI: IRQ10 SCI: Edge set to level trigger
After this the machine is dead in the water.
No magic sysrq or anything.
Any ideas how to solve this issue ?
I googled around a bit but found nothing usefull.
I upgraded bios to latest available from compaq, with no different results.
Help/suggestions appreciated.
Danny
Signature · 4 lines
/"\ | Dying is to be avoided because \ / ASCII RIBBON CAMPAIGN | it can ruin your whole career X against HTML MAIL | / \ and POSTINGS | - Bob Hope
Quoted 16 lines · Danny ter Haar
My Compaq presario 700EA locks up dead during boot with
ACPI enabled. With bootoption acpi=off (or not compiled into the kernel) the machine works just fine.I put on acpi debug and typed over by hand (laptop's dont have serial ports these days anymore) :
ACPI: Subsystem revision 20040326
tbxface-0017[03]acpi_load_tables: ACPI tables succesfully acquired Parsing all Control Methods: [......]
Table [DSDT] (id F005) - 433 Objects with 44 Devices 109 Methods 15 Regions
Parsing all Control Methods:
Table [SSDT] (id f003) - 3 objects with 0 Devices 0 Methods 0 Regions
ACPI: IRQ10 SCI: Edge set to level trigger
Quoted 2 lines
After this the machine is dead in the water.
No magic sysrq or anything.
It sounds as if some driver is using IRQ10, and that another device is also on that IRQ. This will create an interrupt storm the moment you switch the triggering from edge to level....
So: Which devices use IRQ10 when the computer works?
Roger.
Signature · 3 lines
** [email protected] ** http://www.BitWizard.nl/ ** +31-15-2600998 ** *-- BitWizard writes Linux device drivers for any device you may have! --* **** "Linux is like a wigwam - no windows, no gates, apache inside!" ****
Quoted 7 lines · Rogier Wolff
Quoted 2 lines
After this the machine is dead in the water.
No magic sysrq or anything.It sounds as if some driver is using IRQ10, and that another device is also on that IRQ. This will create an interrupt storm the moment you switch the triggering from edge to level....
So: Which devices use IRQ10 when the computer works?
Len Brown from Intel sent me :
"try booting with "nolapic" (or disable LOCAL_APIC in the kernel build)"
That indeed solved my problem, i can now use poweroff etc.
I will add a bugreport to http://bugzilla.kernel.org/show_bug.cgi?id=1682
l8er this week ;-)
Danny
Signature · 3 lines
"If Microsoft had been the innovative company that it calls itself, it would have taken the opportunity to take a radical leap beyond the Mac, instead of producing a feeble, me-too implementation." - Douglas Adams -