Skip to contentSkip to conversation

ip addr add vs ifconfig eth0:1

LARTC [email protected] 3 participants 3 messages Apr 4, 2004 – Apr 5, 2004

lore
Share & tools
lore
#0 lore raw

A stupid question: which is recomended?

I have 1 interface eth0. I need to set about 20 virtual interfaces eth0:xx on it.

If I create them with ifconfig eth0:xx I see it with ifconfig and with ip addr ls. If I set it with 'ip addr add', ifconfig don't show them, but 'ip addr ls' and 'route' show them. So, which is better?

Thanks in advance.
PS: I can't find anywhere docs about relationship between 'old' utilities ifconfig, route, etc and the iproute2 package. Point me to some comparision between them, please.

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw
Quoted 6 lines · On Sun, Apr 04, 2004 at 07:44:50PM +0300, [email protected] wrote:

I have 1 interface eth0. I need to set about 20 virtual interfaces eth0:xx on it.

If I create them with ifconfig eth0:xx I see it with ifconfig and with ip addr ls. If I set it with 'ip addr add', ifconfig don't show them, but 'ip addr ls' and 'route' show them. So, which is better?

If you create them with:
"ip addr add ... dev eth0 label eth0:xx"
you can still give them ifconfig-compatible labels, visible with both tools.

Signature · 4 lines
Alan Ford * [email protected] 
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
#2 lore raw
In reply to [email protected]

Hello,

: A stupid question: which is recomended?

The iproute2 tools expose all of the complexity of the Linux kernel in a clear and transparent way, so I recommend iproute2 for any but the most pedestrian uses of IP addressing on Linux boxen. Naturally, for workstations and standalone boxen, there's no need--you will get the same result by using the much more platform agnostic ifconfig tool.

: I have 1 interface eth0. I need to set about 20 virtual interfaces : eth0:xx on it.
:
: If I create them with ifconfig eth0:xx I see it with ifconfig and with : ip addr ls. If I set it with 'ip addr add', ifconfig don't show them, : but 'ip addr ls' and 'route' show them. So, which is better?

As a previous poster (Alan Ford) has suggested, you can use the label parameter to your "ip addr" command lines. This will allow you to use both ifconfig and iproute2 tools to see what IP addresses are active on a given interface.

: PS: I can't find anywhere docs about relationship between 'old' : utilities ifconfig, route, etc and the iproute2 package. Point me to : some comparision between them, please.

I don't have any documentation specifically about the relationship between the two utilities, although you may find some answers in my guide [0]. Each utility reports (in a different way) on the current configuration of interfaces and their addresses.

Best of luck,

-Martin

[0] http://linux-ip.net/
http://linux-ip.net/html/tools-ip-management.html

Signature · 5 lines
Martin A. Brown --- SecurePipe, Inc. --- [email protected]

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/