Add support for OV5647 sensor

new file mode 100644
index 0000000..fa6b09c
@@ -0,0 +1,29 @@
+Omnivision OV5657 raw image sensor
+---------------------------------
+
+OV5657 is a raw image sensor with MIPI CSI-2 and CCP2 image data interfaces
+and CCI (I2C compatible) control bus.
+
+Required properties:
+
+- compatible	: "ov5647";
+- reg		: I2C slave address of the sensor;
+- clocks	: should contain list of phandle and clock specifier pairs
+		  according to common clock bindings for the clocks described
+		  in the clock-names property;
+- clock-names	: should contain "extclk" entry for the sensor's EXTCLK clock;
+
+Optional properties:
+
+- clock-frequency : the frequency at which the "extclk" clock should be
+		    configured to operate, in Hz; if this property is not
+		    specified default 27 MHz value will be used.
+
+The common video interfaces bindings (see video-interfaces.txt) should be
+used to specify link to the image data receiver. The OV5657 device
+node should contain one 'port' child node with an 'endpoint' subnode.
+
+Following properties are valid for the endpoint node:
+
+- data-lanes : (optional) specifies MIPI CSI-2 data lanes as covered in
+  video-interfaces.txt.  The sensor supports only two data lanes.

index 81d940b..06697fc 100644
@@ -8106,6 +8106,13 @@ M:	Harald Welte <[email protected]>
 S:	Maintained
 F:	drivers/char/pcmcia/cm4040_cs.*
 
+OMNIVISION OV5647 SENSOR DRIVER
+M:	Ramiro Oliveira <[email protected]>
+L:	[email protected]
+T:	git git://linuxtv.org/media_tree.git
+S:	Maintained
+F:	drivers/media/i2c/ov5647.c
+
 OMNIVISION OV7670 SENSOR DRIVER
 M:	Jonathan Corbet <[email protected]>
 L:	[email protected]

index 993dc50..1d4891b 100644
@@ -500,6 +500,17 @@ config VIDEO_OV2659
 	  To compile this driver as a module, choose M here: the
 	  module will be called ov2659.
 
+config VIDEO_OV5647
+	tristate "OmniVision OV5647 sensor support"
+	depends on I2C && VIDEO_V4L2
+	depends on MEDIA_CAMERA_SUPPORT
+	---help---
+	  This is a Video4Linux2 sensor-level driver for the OmniVision
+	  OV5647 camera.
+
+	  To compile this driver as a module, choose M here: the
+	  module will be called ov5647.
+
 config VIDEO_OV7640
 	tristate "OmniVision OV7640 sensor support"
 	depends on I2C && VIDEO_V4L2

index 94f2c99..a732a0c 100644
@@ -80,3 +80,4 @@ obj-$(CONFIG_VIDEO_IR_I2C)  += ir-kbd-i2c.o
 obj-$(CONFIG_VIDEO_ML86V7667)	+= ml86v7667.o
 obj-$(CONFIG_VIDEO_OV2659)	+= ov2659.o
 obj-$(CONFIG_VIDEO_TC358743)	+= tc358743.o
+obj-$(CONFIG_VIDEO_OV5647)	+= ov5647.o