Skip to contentSkip to conversation

spi: cadence-qspi: defer runtime support on socfpga if reset bit is enabled

PATCH In review Khairul Anuar Romli 2 participants 2 messages Sep 10, 2025 – Sep 19, 2025 1 message not in the archive SPI

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw

PATCH 1/1 spi: cadence-qspi: defer runtime support on socfpga if reset bit is enabled

Enabling runtime PM allows the kernel to gate clocks and power to idle devices. On SoCFPGA, a warm reset does not fully reinitialize these domains.This leaves devices suspended and powered down, preventing U-Boot or the kernel from reusing them after a warm reset, which breaks the boot process.

Fixes 4892b374c9b7 ("mtd: spi-nor: cadence-quadspi: Add runtime PM support")
---
 drivers/spi/spi-cadence-quadspi.c | 53 +++++++++++++++++++++----------
 1 file changed, 36 insertions(+), 17 deletions(-)
drivers/spi/spi-cadence-quadspi.c +36 -17
index 9bf823348cd3..d288e9d9c187 100644
@@ -46,6 +46,7 @@ static_assert(CQSPI_MAX_CHIPSELECT <= SPI_CS_CNT_MAX);
 #define CQSPI_DMA_SET_MASK		BIT(7)
 #define CQSPI_SUPPORT_DEVICE_RESET	BIT(8)
 #define CQSPI_DISABLE_STIG_MODE		BIT(9)
+#define CQSPI_DISABLE_RUNTIME_PM	BIT(10)
 
 /* Capabilities */
 #define CQSPI_SUPPORTS_OCTAL		BIT(0)
@@ -1468,14 +1469,17 @@ static int cqspi_exec_mem_op(struct spi_mem *mem, const struct spi_mem_op *op)
 	int ret;
 	struct cqspi_st *cqspi = spi_controller_get_devdata(mem->spi->controller);
 	struct device *dev = &cqspi->pdev->dev;
+	const struct cqspi_driver_platdata *ddata = of_device_get_match_data(dev);
 
 	if (refcount_read(&cqspi->inflight_ops) == 0)
 		return -ENODEV;
 
-	ret = pm_runtime_resume_and_get(dev);
-	if (ret) {
-		dev_err(&mem->spi->dev, "resume failed with %d\n", ret);
-		return ret;
+	if (!(ddata && (ddata->quirks & CQSPI_DISABLE_RUNTIME_PM))) {
+		ret = pm_runtime_resume_and_get(dev);
+		if (ret) {
+			dev_err(&mem->spi->dev, "resume failed with %d\n", ret);
+			return ret;
+		}
 	}
 
 	if (!refcount_read(&cqspi->refcount))
@@ -1491,7 +1495,8 @@ static int cqspi_exec_mem_op(struct spi_mem *mem, const struct spi_mem_op *op)
 
 	ret = cqspi_mem_process(mem, op);
 
-	pm_runtime_put_autosuspend(dev);
+	if (!(ddata && (ddata->quirks & CQSPI_DISABLE_RUNTIME_PM)))
+		pm_runtime_put_autosuspend(dev);
 
 	if (ret)
 		dev_err(&mem->spi->dev, "operation failed with %d\n", ret);
@@ -1985,11 +1990,12 @@ static int cqspi_probe(struct platform_device *pdev)
 			goto probe_setup_failed;
 	}
 
-	pm_runtime_enable(dev);
-
-	pm_runtime_set_autosuspend_delay(dev, CQSPI_AUTOSUSPEND_TIMEOUT);
-	pm_runtime_use_autosuspend(dev);
-	pm_runtime_get_noresume(dev);
+	if (!(ddata && (ddata->quirks & CQSPI_DISABLE_RUNTIME_PM))) {
+		pm_runtime_enable(dev);
+		pm_runtime_set_autosuspend_delay(dev, CQSPI_AUTOSUSPEND_TIMEOUT);
+		pm_runtime_use_autosuspend(dev);
+		pm_runtime_get_noresume(dev);
+	}
 
 	ret = spi_register_controller(host);
 	if (ret) {
@@ -1997,12 +2003,17 @@ static int cqspi_probe(struct platform_device *pdev)
 		goto probe_setup_failed;
 	}
 
-	pm_runtime_put_autosuspend(dev);
+	if (!(ddata && (ddata->quirks & CQSPI_DISABLE_RUNTIME_PM))) {
+		pm_runtime_put_autosuspend(dev);
+		pm_runtime_mark_last_busy(dev);
+		pm_runtime_put_autosuspend(dev);
+	}
 
 	return 0;
 probe_setup_failed:
 	cqspi_controller_enable(cqspi, 0);
-	pm_runtime_disable(dev);
+	if (!(ddata && (ddata->quirks & CQSPI_DISABLE_RUNTIME_PM)))
+		pm_runtime_disable(dev);
 probe_reset_failed:
 	if (cqspi->is_jh7110)
 		cqspi_jh7110_disable_clk(pdev, cqspi);
@@ -2013,7 +2024,11 @@ static int cqspi_probe(struct platform_device *pdev)
 
 static void cqspi_remove(struct platform_device *pdev)
 {
+	const struct cqspi_driver_platdata *ddata;
 	struct cqspi_st *cqspi = platform_get_drvdata(pdev);
+	struct device *dev = &pdev->dev;
+
+	ddata = of_device_get_match_data(dev);
 
 	refcount_set(&cqspi->refcount, 0);
 
@@ -2026,14 +2041,17 @@ static void cqspi_remove(struct platform_device *pdev)
 	if (cqspi->rx_chan)
 		dma_release_channel(cqspi->rx_chan);
 
-	if (pm_runtime_get_sync(&pdev->dev) >= 0)
-		clk_disable(cqspi->clk);
+	if (!(ddata && (ddata->quirks & CQSPI_DISABLE_RUNTIME_PM)))
+		if (pm_runtime_get_sync(&pdev->dev) >= 0)
+			clk_disable(cqspi->clk);
 
 	if (cqspi->is_jh7110)
 		cqspi_jh7110_disable_clk(pdev, cqspi);
 
-	pm_runtime_put_sync(&pdev->dev);
-	pm_runtime_disable(&pdev->dev);
+	if (!(ddata && (ddata->quirks & CQSPI_DISABLE_RUNTIME_PM))) {
+		pm_runtime_put_sync(&pdev->dev);
+		pm_runtime_disable(&pdev->dev);
+	}
 }
 
 static int cqspi_runtime_suspend(struct device *dev)
@@ -2112,7 +2130,8 @@ static const struct cqspi_driver_platdata socfpga_qspi = {
 	.quirks = CQSPI_DISABLE_DAC_MODE
 			| CQSPI_NO_SUPPORT_WR_COMPLETION
 			| CQSPI_SLOW_SRAM
-			| CQSPI_DISABLE_STIG_MODE,
+			| CQSPI_DISABLE_STIG_MODE
+			| CQSPI_DISABLE_RUNTIME_PM,
 };
 
 static const struct cqspi_driver_platdata versal_ospi = {
Signature · 1 line
2.35.3
maintainer
#2 lore raw
Quoted 8 lines · Khairul Anuar Romli

Enabling runtime PM allows the kernel to gate clocks and power to idle devices. On SoCFPGA, a warm reset does not fully reinitialize these domains.This leaves devices suspended and powered down, preventing U-Boot or the kernel from reusing them after a warm reset, which breaks the boot process.

[...]

Applied to

https://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi.git for-next

Thanks!

[1/1] spi: cadence-qspi: defer runtime support on socfpga if reset bit is enabled

      commit: 30dbc1c8d50f13c1581b49abe46fe89f393eacbf

All being well this means that it will be integrated into the linux-next tree (usually sometime in the next 24 hours) and sent to Linus during the next merge window (or sooner if it is a bug fix), however if problems are discovered then the patch may be dropped or reverted.

You may get further e-mails resulting from automated or manual testing and review of the tree, please engage with people reporting problems and send followup patches addressing any issues that are reported if needed.

If any updates are required or you are submitting further changes they should be sent as incremental updates against current git, existing patches will not be replaced.

Please add any relevant lists and maintainers to the CCs when replying to this mail.

Thanks,
Mark