Skip to contentSkip to conversation

Problem with 'vtop' command in crash utility

DISCUSSION Rasha Eqbal 1 participant 2 messages Jul 6, 2009 – Jul 7, 2009

lore
Share & tools
lore
#0 lore raw

Hello everyone,

I have installed Wubi-8.10 on my Intel x86 32-bit system. The kernel version I am working with is 2.6.28. On running crash when I use the vtop command, I get the following error:

read error: physical address <address> type: page table

The steps I follow are:

$crash vmlinux
crash> vm

from here I pick out the start address of any one vm region, say <vm_start> and do:

crash> vtop <vm_start>

This is where I get the error.

This I found is being caused due to the inability of the kernel to directly access the page tables which are present in high memory for kernel version 2.6. So I shifted the page tables to normal memory by turning off CONFIG_HIGHPTE. Now I am able to run vtop. But I want to have the page tables in high memory itself. Is there a way to successfully run vtop command with this setting i.e. page tables in high memory.

Thanks in advance for your help.

--
Rasha Eqbal
IIIrd Yr Undergraduate Student
Department of Computer Science and Engineering
IIT Kharagpur, India

#1 lore raw

The crash version im using is crash 4.0-6.3

--
Rasha Eqbal
IIIrd Yr Undergraduate Student
Department of Computer Science and Engineering
IIT Kharagpur, India