Skip to contentSkip to conversation

<pci_lookup_name: buffer too small>

DISCUSSION Kalin KOZHUHAROV 1 participant 1 message Feb 2, 2006

lore
Share & tools
lore
#0 lore raw

Hi there.

Not sure if this is kernel problem or pcuitils-2.2.0 problem, please have a look.

~ # uname -a
Linux char 2.6.15.1-K01_P4_server #3 SMP Wed Jan 25 22:57:16 JST 2006 i686 Intel(R) Pentium(R) 4 CPU 3.00GHz GenuineIntel GNU/Linux

~ # lspci |grep 01:04.0 && echo && lspci -G -xxxx -vv -s 01:04.0
01:04.0 Mass storage controller: <pci_lookup_name: buffer too small> (rev 13)

Trying method 1......using /sys/bus/pci...OK
Decided to use Linux-sysfs
01:04.0 Mass storage controller: <pci_lookup_name: buffer too small> (rev 13)
Subsystem: ASUSTeK Computer Inc. Unknown device 813a
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-

        Latency: 0 (2000ns min, 2000ns max)
        Interrupt: pin A routed to IRQ 18
        Region 0: I/O ports at d400 [size=8]
        Region 1: I/O ports at d000 [size=4]
        Region 2: I/O ports at c800 [size=8]
        Region 3: I/O ports at c400 [size=4]
        Region 4: I/O ports at c000 [size=16]
        Expansion ROM at 80000000 [disabled] [size=128K]
        Capabilities: [80] Power Management version 2
                Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA

PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
00: 83 12 12 82 07 00 30 02 13 00 80 01 00 00 00 00 10: 01 d4 00 00 01 d0 00 00 01 c8 00 00 01 c4 00 00 20: 01 c0 00 00 00 00 00 00 00 00 00 00 43 10 3a 81 30: 00 00 fc cf 80 00 00 00 00 00 00 00 0b 01 08 08 40: f0 a0 36 01 08 00 08 00 02 02 00 00 04 02 04 02 50: 00 20 00 00 a3 00 31 31 a3 00 31 31 00 1a 01 00 60: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 70: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 80: 01 00 02 00 00 00 00 00 00 00 00 00 00 00 00 00 90: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
a0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
b0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
c0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
d0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
e0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
f0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00

The controller in question is on board Asus P5GDC-V Deluxe and I just enabled it in BIOS, because I run shoert of IDE channels:

~ # dmesg |grep -i IT8212

[    1.636300] IT8212: IDE controller at PCI slot 0000:01:04.0
[    1.636320] IT8212: chipset revision 19
[    1.636326] IT8212: 100% native mode on irq 18

Kalin.

Signature · 3 lines
|[ ~~~~~~~~~~~~~~~~~~~~~~ ]|
+-> http://ThinRope.net/ <-+
|[ ______________________ ]|