Problems (lockup/hang) with PCI-X slot on X5DPL motherboard
I'm getting to my wits end, so any help would be greatly appreciated.
I've got two disk servers, on with SuperMicro X5DPL-iGM motherboard, the other with a X5DPL-TGM board. These system use the E7501 chipset, and provide to PCI-X buses. One for slots 4 and 5, the other for slot 6 and the embedded Intel 82545EM GigE NIC.
I have had nothing but trouble trying to use slot 6 on these machines. Recently I've been trying with a MV88SX6081 133MHz PCI-X card. In both machines I get lockups when trying to use the controller. I also see corruption on the on-board NIC on the TGM (though not on the iGM) with the card in slot 6.
I'm running Fedora Core 4 with kernel 2.6.12-1.1456_FC4smp and mv_sata driver 3.6.1. I'm stuck on the older kernel because of the mv_sata driver.
Now, maybe this is all the fault of the mv_sata driver, but I believe I had problems on the iGM machine with a Intel 82545GM PCI-X nic in slot 6 as well which does not use the mv_sata driver at all normally.
Thoughts?
- Orion
Signature · 4 lines
Orion Poplawski System Administrator 303-415-9701 x222 Colorado Research Associates/NWRA FAX: 303-415-9702 3380 Mitchell Lane, Boulder CO 80301 http://www.co-ra.com
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 6 lines · Jesse Brandeburg
On these supermicro systems often they have jumpers to control the slots, are they set correctly? Make sure that if your e1000 and slot six are sharing a bus, that neither of them is running at faster than PCI-X 100 MHz (check in ethtool -d ethX for e1000)
Is there a way to find out bus speed for other slots/cards?
Quoted 4 lines
so do the other slots work okay with your MV card? The supermicro systems had tons and tons of ACPI table problems, so you may want to look closely at your dmesg and / or try acpi=off kernel boot line.
In general, yes, though I just had a lockup with this new MV card in my test system. Otherwise, my X5DPL-TGM with on MV card in slot 4 and one Intel GigE in slot 5 has been quite stable.
Quoted 2 lines
If you think you're having a network problem posting to [email protected] would be good.
I think it's only related to device/bus issues, not in general.
Thanks a lot for the reply. I'll be trying to turn down the bus speed in the BIOS to see if that help.
Signature · 4 lines
Orion Poplawski System Administrator 303-415-9701 x222 Colorado Research Associates/NWRA FAX: 303-415-9702 3380 Mitchell Lane, Boulder CO 80301 http://www.co-ra.com