Skip to contentSkip to conversation

QCA6147 (rev 32) Speed and Connectivity Issues

DISCUSSION Filip Fila 1 participant 1 message May 15, 2017 Qualcomm Atheros ATH10K wireless driver

lore
Share & tools
lore

Filip Fila

author
#0 lore raw

Hello,

I recently bought a Lenovo V510 laptop that comes with a QCA6147 (rev 32) chip.

I am having quite a few issues with it in Linux. I've researched all I could on the internet and haven't been able to solve them so I come to you as a last resort.

The issue is that the chip does not work with NetworkManager at all - wireless won't turn itself on, meaning no connections are listed.

It's possible to connect through cli with netctl or connman, however, there are three issues:

1) the max speed is roughly half the amount it reaches in Windows;
2) the speed will fluctuate a lot, reaching its capped max and then instantly dropping to even 10-20% of the maximum connection speed, sometimes even to speeds like 50 kb/s;
3) once in a while, I assume the drivers don't load during boot and no connection can be established.

The kernel used is 4.11, NetworkManager is at 1.8 and I also replaced all the firmware files with the latest ones from Kvalo's GitHub repo, but the result is the same.

Could you please let me know if this is perhaps a hardware problem, and if not, are this chip's drivers going to be updated so that it works out of the box (with NetworkManager and its GUI applets) and at full speed? If I could be of assistance with any kind of output messages, I will gladly do my best to help out.

Best regards,
Filip Fila

_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k