Skip to contentSkip to conversation

telnet hanging issues in kernel 2.6.16

DISCUSSION Roy Zacharias 2 participants 2 messages Jan 28, 2008

lore
Share & tools
lore
#0 lore raw

Hello,

This is my first time posting on this list. Currently, I am working on a powerpc board and I encounter some problems. When I do the following:

1. Login to my card from pc as root
2. Run command (i.e. ls, ps, etc.)
3. Wait 30 min-1hr
4. Run command

After the fourth step, I only see the partial output of the command and my telnet session becomes unresponsive and I have to connect again. This same issue occurs even on ssh leading me to believe that there is an inherent network driver issue. I am using the e100 drivers in the 2.6.16 kernel. Are there any issues with this driver? Are there any patches for it? I am running on busybox 1.7.1 with the eldk 4.1 toolchain. I appreciate anyone's help.

Thanks,
Royous

#1 lore raw
Quoted 6 lines · Roy Zacharias

Hello,

This is my first time posting on this list. Currently, I am working on a powerpc board and I encounter some problems. When I do the following:

Quoted 8 lines

1. Login to my card from pc as root
2. Run command (i.e. ls, ps, etc.)
3. Wait 30 min-1hr
4. Run command

After the fourth step, I only see the partial output of the command and my telnet session becomes unresponsive and I have to connect again.

Hm, could it be an MTU/MSS/SACK/Window Sizing issue?
When you see the partial output, the window is enlarged because of the bulk output you get from the command.