dma hardware underrun
Hi all,
I'm currently experiencing a tough DMA underrun problem.
The system is like:
global bus
||
data-compressor ------||------//---- memory
IDE-PCI harddisk -----||
data-decompressor ----||
data-consumer --------||
||1. harddisk has the compressed data, read to compressed buffer by DMA1;
2. data-decompressor gets data from compressed buffer by DMA2, and puts decompressed data to decompressed buffers in ISR;
3. data-consumer eats the decompressed data at an uncompromisable speed;
The data-consumer encounters DMA underrun...
My debugging result shows the underrun goes away if I put 2 printf's in the harddisk ISR. The printf is at milli-seconds whereas the duration of the original ISR is at lower magnitude. In addition, I find a SATA-PCI harddisk does not have the underrun problem. IDE-PCI device gets the trouble.
In addition, all interrupts are at the same priority and ISR's can not be preempted by others.
So, do you have any idea about where the root cause can be hiding? Or what do you think of adding printf's in ISR? (performance? incurring other problems by disabling interrupt too long?)
Thanks!!
-treul
Quoted 4 lines
My debugging result shows the underrun goes away if I put 2 printf's in the harddisk ISR. The printf is at milli-seconds whereas the duration of the original ISR is at lower magnitude. In addition, I find a SATA-PCI harddisk does not have the underrun problem. IDE-PCI device gets the trouble.
Is the SATA controller on the motherboard and the PATA one on the PCI bus ?
Quoted 3 lines
So, do you have any idea about where the root cause can be hiding? Or what do you think of adding printf's in ISR? (performance? incurring other problems by disabling interrupt too long?
On a standard PCI bus an IDE DMA disk can saturate the bus. That may be your underlying problem ?