Skip to contentSkip to conversation

IBM x440 problems on 2.4.20 to 2.4.20-rc1-ac3

DISCUSSION john stultz 2 participants 2 messages May 3, 2003 – May 4, 2003 3 messages not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

#2 lore raw
Quoted 7 lines · Alan Cox
Quoted 3 lines · Jack F. Vogel

I has nothing to do with gcc, Alan mentioned the magic (or cursed is probably the better choice :) word, ACPI. The kernel in SLES 8 has the x440 blacklisted so ACPI gets turned off automagically :)

Perhaps someone could submit the x440 blacklist entry to the base kernel ?

Acatually, the blacklist is only needed on the SuSE kernel because they are using a backport of the 2.5 ACPI code. However a tiny bit of code used to ID and enable the summit bits sliped through and the quick solution was to blacklist it until the proper fix is included.

Right now there are no x440 specific patches pending for Vanilla 2.4 or Vanilla 2.5. As issues are found and resolved, patches will be submitted first thing for inclusion into mainline.

thanks
-john

A message that is not in the archive (sent off-list or not yet received): [email protected]

#4 lore raw
Quoted 3 lines · john stultz

Right now there are no x440 specific patches pending for Vanilla 2.4 or Vanilla 2.5. As issues are found and resolved, patches will be submitted first thing for inclusion into mainline.

x440 doesnt work with the ACPI in the 2.4 update from Intel either. I don't really care whether IBM fix that before it goes into 2.4.22pre1 or after.