Tigon3 auto-negotiation and force media
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 6 lines · Kari Kallioinen
Hi,
I have a problem with broadcomm 5700 based card.
It's autonegotiating a wrong media and I can't change the parameters of another end of link. So how I can force specified media technology with tg3-driver? Mii-tool doesn't seem to work and I didn't find any option for tg3-module.
I have the same chip on my motherboard and I have found that doing an 'ifconfig down' followed by 'ifconfig up' will make the chip work. (You may need to restore the default route after doing the above. Or, if you have an appropriate initscript in /etc/rc.d or /etc/init.d you can just use it to restart the network -- same idea but less trouble.)
BTW, how do can you tell that the media choice is wrong? 'ifconfig' doesn't give me that information.
Quoted 2 lines · walt
BTW, how do can you tell that the media choice is wrong? 'ifconfig' doesn't give me that information.
I'm getting the information from dmesg:
tg3: eth0: Link is up at 100 Mbps, half duplex.
Signature · 1 line
Kari Kallioinen