Skip to contentSkip to conversation

Problems w/ RAID-5/sata_promise/PDC20579

DISCUSSION Jarrod Johnson 1 participant 2 messages Jul 19, 2005 – Jul 22, 2005 libata

lore
Share & tools
lore
#0 lore raw

I have a Soltek planar with this controller providing two ports.

As I try to use those ports together with two non-pdc attached sata drives for software raid, the devices hanging off of the PDC controller frequently become unresponive, throwing I/O errors on every attempt to read a sector after a timeout.

Don't have the exact error in front of me, but essentially, it gets command timeout,
then every command to the controller seems to give the same, status of 0xff busy, but not much more informative output.

The situation seems very similar to Jim Ramsays:
http://www.opensubscriber.com/message/[email protected]/1671725.html

Output seems to line up pretty much exactly, except specific sector numbers, of course.

#1 lore raw

Has anyone had success with any SATAII sata_promise card doing large amounts of I/O to multiple drives attached to a controller? If can resync ~20 GB arrays with relatively low risk, but if trying to sustain a resync/restore over 200 GB or so, I rarely complete, especially if booted and doing typical multi-user stuff. During normal operation of a synced raid-5 array, the controller hoses up every few days in the same manner by simple matter of probablity I suppose.

Is there anything I can do to help get this fixed? Or is the solution possibly elsewhere? Is there libata work done recently for SATAII in general?

Quoted 18 lines · Jarrod Johnson

I have a Soltek planar with this controller providing two ports.

As I try to use those ports together with two non-pdc attached sata drives for software raid, the devices hanging off of the PDC controller frequently become unresponive, throwing I/O errors on every attempt to read a sector after a timeout.

Don't have the exact error in front of me, but essentially, it gets command timeout,
then every command to the controller seems to give the same, status of 0xff busy, but not much more informative output.

The situation seems very similar to Jim Ramsays:
http://www.opensubscriber.com/message/[email protected]/1671725.html

Output seems to line up pretty much exactly, except specific sector numbers, of course.