Skip to contentSkip to conversation

About source IP address of IGMP Join sent on loopback interface

DISCUSSION preetham B 1 participant 1 message Mar 22, 2010

lore
Share & tools
lore

preetham B

author
#0 lore raw

Hi,

I am running igmp daemon(igmp router side) and igmp host on same PC. When the host joins on loopback interface, igmp daemon is expected to receive the join report on loopback interface.
Here the join on loopback interface is not going outside the PC(Outside Network).

Is it possible to receive join report (@ igmp daemon) with source IP address as loopback interface address
in above explained setup?

When I run the host, output of netstat command is as below:

#netstat -ng

IPv6/IPv4 Group Memberships
Interface RefCnt Group
--------------- ------ ---------------------
lo 1 239.5.1.7 ==========> This is the group
joined on loopback

lo              1      224.0.0.1
eth0            1      224.0.0.1
eth0            1      239.5.5.6
eth0            1      239.5.5.7

Please cc me in the response

Regards,
Anupam