2.4.1-ac5 - The loopback hang saga continues
Quoted 24 lines
It appears that the loopback-hang parasite is alive and well in 2.4.1-ac5. I've done several tests and I thus provide the following information:
The bug is independent of UP or SMP configured.. it hung both ways, but the box itself is UP.
It appears to hang when internal buffers get filled. The way I see it, copying files from disk to the loopback device (which is a file on the same disk) begins to read from the disk. When the internal read buffer is full, the kernel's queued writes start activating and the data gets copied to the loopback file. This process repeats over and over, as it should normally.
Sometimes however, during a read from the disk, it fills up its buffers and then never makes the accompanying write. In fact, the entire device freezes on the read.
I was able to lessen the frequency of hanging by using the -v flag and tapping ^S and ^Q to temporarily 'pause' copying. This ensures that the read buffer will never become full to the point where it could cause the hang, and appears to work -- until it came across the libc.a file. There was no way to pause it here because nothing is being outputted to the screen while it's copying libc.a. Unfortunately, it fills the buffer too quick and hangs 100% every time. The disk is totally nonresponsive at this point, and a hard reset is necessary.
Quoted 7 lines
I hope this helps anyone who is still tracking down the loopback problem.
Regards,
ByronSignature · 1 line
Byron Stanoszek Ph: (330) 644-3059
I can confirm this. The system totally locks when this occurs. I let it sit all night when it did this the last time, and it didn't recover.
It requires a large file transfer to usually invoke it.
Billy
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/
Re: 2.4.1-ac5 - The loopback hang saga continues (not me ?)
FYI following hints from the linux-crypto mailing-list archives, I am using the following configuration :
linux-2.4.0
patch-int-2.4.0.3
http://www.kernel.org/pub/linux/kernel/people/axboe/patches/2.4.0/loop-1.gz
http://www.kernel.org/pub/linux/kernel/people/axboe/patches/2.4.0/loop-bdev-inc-1.gz
util-linux-2.10oDocumentation/crypto/util-linux-2.10o.patch
I setup an encrypted 2097152000 byte loopback partition and moved 800MB of data there, including a 90MB file.
My only problems are:
- rc.d/init.d/S01reboot sometimes fails to unmount partitions with loop files on them (this already happened with 2.2.17).
- losetup after losetup -d sometimes fails.
-- Pascal
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/