Disable/Enable Flat I²C Commands
PATCH 1/1 Disable/Enable Flat I²C Commands
This is the seconded version of "Disable/Enable Flat I?C Commands" Patch. It has invert logic, that means a new define disables the flat command instaed of reenable.
Since CONFIG_I2C_CMD_TREE are defined, the old flat i2c commands are still present.
This patch disables the old flat command by default, if
both CONFIG_I2C_CMD_TREE and CONFIG_I2C_CMD_FLAT are defined. The new option CONFIG_I2C_CMD_NO_FLAT makes it possible to dissable the flat, when tree commands are used.
---
README +3 -0
@@ -1306,6 +1306,9 @@ The following options need to be configured: older 'imm', 'imd', 'iprobe' etc. commands are considered deprecated and may disappear in the future. + CONFIG_I2C_CMD_NO_FLAT enables the old flat i2c commands like + 'imm', 'imd', 'iprobe' etc. if CONFIG_I2C_CMD_TREE is defined. + CONFIG_HARD_I2C selects a hardware I2C controller. CONFIG_SOFT_I2C configures u-boot to use a software (aka
common/cmd_i2c.c +2 -0
@@ -1324,6 +1324,7 @@ U_BOOT_CMD(#endif );#endif /* CONFIG_I2C_CMD_TREE */ +#if (!defined(CONFIG_I2C_CMD_NO_FLAT ) || !defined(CONFIG_I2C_CMD_TREE )) U_BOOT_CMD( imd, 4, 1, do_i2c_md, \ "i2c memory display", \
@@ -1369,6 +1370,7 @@ U_BOOT_CMD("chip address[.0, .1, .2] [# of objects]\n" " - loop, reading a set of addresses\n" ); +#endif /* CONFIG_I2C_CMD_FLAT/TREE */ #if defined(CONFIG_CMD_SDRAM ) U_BOOT_CMD(
PATCH 1/1 Disable/Enable Flat I²C Commands
Hi Jens,
Quoted 5 lines · Jens Scharsig
This is the seconded version of "Disable/Enable Flat I?C Commands" Patch. It has invert logic, that means a new define disables the flat command instaed of reenable.
Quoted 7 lines
Since
CONFIG_I2C_CMD_TREEare defined, the old flat i2c commands are still present.
This patch disables the old flat command by default, if
bothCONFIG_I2C_CMD_TREEandCONFIG_I2C_CMD_FLATare defined. The new optionCONFIG_I2C_CMD_NO_FLATmakes it possible to dissable the flat, when tree commands are used.
As we discussed in the other thread, the flat commands are going away after the next release, so why bother with this?
regards,
Ben
PATCH 1/1 Disable/Enable Flat I²C Commands
Hi Ben,
Quoted 2 lines
As we discussed in the other thread, the flat commands are going away after the next release, so why bother with this?
Thats right. It was only a timing problem by myself.
Best regard,
Jens Scharsig